Big Dan

Is that Bilstein only or do you, personally, always mount the shock body towards the frame?

I used McMaster-Carr. That's an option.

Eeeeeesh Sent from my Pixel 2 XL using Tapatalk

What's the listing number (or link)? I'm not spending that kind of money on it, but, I would like to look at it.

Did you document the testing in another thread? If not, what sort of testing did you have to do?

Thanks. The cruise control isn't functioning but I'm not so sure I want to get in to tackling it. If I remove things, I wanted to make sure I was removing the right things. From what I read, the CC for renix is either a simple fix or pulling teeth. Sent from my Pixel 2 XL using Tapatalk

Am I correct in stating that the circled wiring is all related to cruise control? Sent from my Pixel 2 XL using Tapatalk

BLUF - run it. The luk throw out bearing is fine. That whole "ITS GOT PLASTIC" is completely blown out of proportion. Theres lots of info from Jerry Bransford (a TJ guru) about the luk bearings.

https://www.ebay.com/itm/EGR-Valve-WELLS-EGR365-fits-88-90-Jeep-Cherokee-4-0L-L6/254094123444

He's in PA

I have the same issue...my O2 sensor isnt functioning, I'm assuming. I had an AC Delco, in there, and swapped it out for NTK last night. I'm hoping it was just a sensor problem.

Eeesh. That's what I had on my 86. That just made the sourcing of parts even more difficult.

I've got mine pulled, from when I did the AX-15 swap. Still, several states away, however.

You may have it listed, however, I'm on tapatalk and can't see it. What's your location? Sent from my Pixel 2 XL using Tapatalk

It's called a starter relay Sent from my Pixel 2 XL using Tapatalk

Depends on how bad everything is. Post a picture. If the clutch fluid didn't eat anything up and it's just oxidation, contact cleaner will help. Sent from my Pixel 2 XL using Tapatalk

Headlight harness Sent from my Pixel 2 XL using Tapatalk

Most cleaver Sent from my Pixel 2 XL using Tapatalk

Not without a lot of fabrication. Any seat will fit with a lot of fabrication. For ease of mounting, focus on 84-94 XJ seats

Do you know why the gauges were reading too high if it was under charged? Sent from my Pixel 2 XL using Tapatalk

What "kit" are you getting from jeepair? I thought that they only offered CJ/YJ/TJ kits. Other vehicles had to have components sourced in a piecemeal fashion. Is that incorrect?

Sounds like a return it is. Thanks. Sent from my Pixel 2 XL using Tapatalk

I'm sure it's not economical..I was only considering it, due to my current situation. However, I can't find a part that is only a unit bearing (no hub attached). If that is, indeed, not available, I'll return the hubs. Sent from my Pixel 2 XL using Tapatalk

Ive had them for a few years...no problems thus far. As Pete said, noise in what way?

Alright, so, I goofed up and didnt read the part numbers correctly. I ordered two NOS MOPAR 53000234 for a Dana 30. I had believed this to be the complete wheel hub bearing assembly. After further research, this is just the hub, with studs. There is no unit bearing attached. Is it even possible to get a unit bearing, without a hub, and press it in? I havent been able to find one. If not, why was the hub, only, available as a separate part?