MiNi Beast

keep it tight and do it right.

did you have to swap the crossmember?

never thought it be easier to flip the jeep over to install drive train. nice

cleaned up nice.

i have swapped in the auto from a 94 xj so converting back to manual and hence have to replace all the parts that i no longer have. i atticatpated the clutch kit to be complete and thus give me all the parts needed to put t ax15 back in. however i didnt think when reading parts list of the line not already attached to slave like with the pre filled setup you can aquire for $100. i presumed this not as i forget which is why i went back to this thread for reference as to what i did the first time. however slide shows and pic site no longer working so why I'm reposting as i go along this time so to have a reference of it for next time.

easy off ftw. but was hard to find at the stores, target had some though. cleaned it up nice. so dragging as wanted to get this in yesterday but got busy with cleaning ceiling fans.

clean it up with easy off

build another one for me good sir.

yeah i was looking at this one. https://m.northerntool.com/shop/tools/product_200461868_200461868

better then a whistler.

done yet? ill be getting mine in this evening once I'm done cleaning house like a good boy.

hey yeah i need a spout for the one i have. thanks yeah i want to move the gas tank up into the box and was debating a fuel cell of bigger capacity for those longer road trips in the bush eh. living on the edge going in the middle of nowhere with a backwards gage thats couple gallons off and we'll say I'm tired of the gas can funnel fill up when i only need an extra 50 miles or 10 trail miles. ummm and my gas tank straps are rusty again so need another set soon.

i like it.

coils.. interesting... what about air bags?

Awesome!!!!!

lame. you couldn't get a better shot mr. mj of the month?

better take the roll bar with the bumper as well.

delco alt or motorcraft? possibly a field wire. need to get it tested though and see. yelow fm ign. switch ---\__ run side solenoid (grn wire) yelow fm ign. mod. ----/ coil wire (Yellow w/ red stripe) grn fm ign mod. ------/ resistor wire fm alt. (solid wire) all these wires are connected together.

fusible link?

run it.

no.

so is it hot when running? perhaps for a voltmeter or something standalone in need of charging.