Search the Community
Showing results for tags 'full width axles.'.
My truck is an 89 with 2.5L and 4spd. I bought it a little over a year ago for $400 and have been tinkering on it since. When i got the truck it was basicly stock other then the 31x10.5 15s, the lights on the sides of the cowl which were cosmetic and had never been wired in , and a flowmaster muffler,it ran and drove but had been neglected/abused and needed ALOT of little things. First upgrade i did was a guage swap,my truck is a base model with idiot lights so i swapped them out for guages from a 1990 XJ. No photos but I'm sure youve seen MJ/XJ guages next project was the interior,the truck had some thrashed bucket seats out of some car thrown in it and bolted onto wood blocks screwed into the floor. I tore all that out,fabricated new mounts and put in a set from a 97 Dakota. next the rear, the rear bumper was missing and the truck had a reciever that hung below the missing bumper.I chopped off the reciever and tucked it up then made a rolled pan to cover it then I installed a winch bumper,I had one laying around from my old 83 F250. It was way too big so after a chat with a torch and welder it looked like this Now time for a lift,I decided to install a 5" lift from Rocky-road outfitters,It uses old man EMU springs and i installed long travel shocks. the entire install took me about 7 hrs to complete by myself. the truck drives much better on the road now and has lots of flex off road. the other day i decided to redo my headliner since the old one had been cut out but i wanted something different so i customized it. And thats about were I'm at now,with lots still to do.