Salvagedcircuit

The rollbar is whole again. The mopar gods have been appeased. It'll be painted up nice soon enough. Woo hoo.

So this is how you are able to have all those brackets, bolts, clips, lights etc... I find myself needing. Nice

Yep. Excel sheet works. Otherwise the google "sheets" version so can pull it up on the phone. I keep a google doc of the repairs and analysis of my comanche. It's a novel at this point lol

This is some seriously excellent work. Hats off to you sir!

Did you check the in-line fuse that's hidden inside the passenger side of the lower dash? I think it's an ATO/ATC style 10a or 20a fuse.

Rockauto seems to be the cheapest. It's $145 after shipping and discounts. not too shabby. Rockauto has 5% discount codes frequently: 280957379195134341 https://old.reddit.com/r/RockAuto/comments/1g09bbd/5_discount_code/ It seems ACC carpets is the supplier. I got the vinyl version. It's not everyone's favorite, but the comanche is my work truck and I wanted some durability. You have to wrestle a bit with the vinyl and it doesn't ever perfectly contour flat to all the geometry of the cab floor, but it's close enough that I don't care or notice. A lot of folks seem to like the non-vinyl version because it contours better and is easier to cut and manipulate.

This is how it's done. There's barely anything there left to scrap. The taps are playing, the buglers are beginning to retire. Dang good run I'd say. Edit: you missed the plastic door sills! How could you

You made the one and only correct choice! Congrats good sir!

Thanks! That brushguard was an excellent score. I had to drive 100mi round trip to grab my sport bar and it was hacked up

Hahaha. Thanks!

Woah, same color as mine but with the brush guard. That thing looks incredibly straight. Built like a brick dunny! Greets from the states!

Nice. 340k never looked so good

1986 Comanche X Longbed sold for $810 on 10/6/24 What a steal https://www.ebay.com/itm/176601821901

Aww yeah. Out and about.

If My comanche ever gets stuck, this is how I would want to be pulled out Nice job!

Woah, is this one going on a 6000+ mile adventure across the alps, on a tour of europe and then by barge back to the states

Awesome! I was thinking of using a car dolly and picking up another comanche locally then putting the transmission and transfer case in neutral and tying down the steering wheel. But this takes the cake

Thanks. It took some trial and error to get the dimensions right. I think the bar was slightly pinched in to fit into the nissan bed. I had to take a 4x4 and jack to open it back up to the right ballpark. It was also painful to square cut the original bar. sweating bullets lol

10/10 will be looking forward to the video

Lookin good

l second this sentiment:

She's almost back to stock

I'm sure you can fix it back to new. This thing's full of 74HC logic and probably a motorola 6800. Built like a brick dunny. She'll be right.

These above amazon o2 sensors are not for the renix Comanches. A correct o2 sensor climbs to 9ohms under heat. The Amazon one plateaus at 5.7ohms. I swapped the c and b pins as mentioned earlier, installed one in my comanche and the engine would not idle correctly. It sounded like it was going to grenade itself.

Oh man, this one's gonna be good