MiNi Beast

231 d is still on the bench yes.

92

Ummm yeah thats how 🤔 they get us. 🇺🇸 😆

Gots one but dosent have a tab for bolt mount...

Yeah I bid on it then next day got email saying it was removed and that if was contacted about it not to respond.

I can check on my trans i just pulled and see if its worth a damn. Give me a hr or so when i get home ill check.

Well i think 🤔, i think i found my tcase leak. Tcase is still good just was leaking, well as i was looking to swap in the 231d and having a pita time trying to find the right rear extension housing, i noticed on the 231j that the front bearing retainer only had 1 bolt, which i didnt think nothing of before, until i was looking at the 231d and noticed 4 bolts holding that one together. So i pulled it and found it was to be sealed up and had no silicone with only the 1 bolt. So perhaps a little bit of goop and a few more bolts and I think it will be good to go back in. 😀 saves me some time-consuming work and will allow me to move on to more pressing issues. 😌 so will slap the tcase back in and move onto leaf springs.

I need to do that myself at some point. Ill stay tuned to see how much of a pita they are.

3.19 for reg and diesel.

Cool.

Which is why i have 2..

I like.

Sweetness! Is it still climbing rocks? 🤔

To bad you couldn't help with his question.

88 comanche exhaust

Yeah thats where mine are mounted as well. Mid mount gives ground clearance and allows that extra inch of shock length. Good plan stan. 👌

Yeah you can swap the plates and run shocks there, and could use a smaller shock. I ran that way then later installed a set of ruff stuff mid mounts for my current set up.

Yeah like Pete i run 2 8" subs in separate boxes behind my bench. Cheap enough speakers being i got them on closeout but their better quality then paper cones. They are 4 ohms i wanna say and can handle 500watts each so i run a 1000watt amp split between the pair. Rocks out the neighborhood 😎. I like to be able to get a back massage while cruising down the road with the doors off. I also have a pair of 5 1/4" in the kick panels on the floor vs the doors. Those are ran straight to radio, no amplifier, and are due to be replaced as they have taken a beating over the years being first set of speakers installed. The next set will be marine grade for the water resistance and built in tweeters which will help me hear it better with the doors off.

Wow. Waiting for all your parts to arrive before tear down, this shows you have come along way.

Id rock it out on the trail.

Try using a heat gun.

Wow, is that thing a transformer?

Looks good 👍. You going to strip the trim down as well to shiny new?

You should be able to get it in 4lo while sitting. Id suggest adjustments before the trail. While clean as well. I got mine dialed in finally but did adjustments while in 4lo as if you start there it should be good.