relyt120 Posted June 15, 2012 Share Posted June 15, 2012 That feeling when you get your first paycheck at a new job and can now do more stuff to your MJ :D Link to comment Share on other sites More sharing options...
relyt120 Posted June 15, 2012 Share Posted June 15, 2012 Spent about 6 hours (from 5 pm til 11pm) working on a bed swap. I removed tail lights from driver and parts truck, removed gas tank skid plate from both trucks, removed gas tank from both trucks (first one was a bit of a challenge with me stuck holding the almost half full tank for nearly 40 minutes while my friends were trying to figure out what was still holding it :mad: , turns out that just loosening the clamps on the filler neck and vent lines isn't enough, you need to go ahead and get the hoses off the metal part :doh: , second one took about 5 minutes), removed exhaust hanger and spare jack from parts truck, and removed 6 of 8 bed bolts from parts truck and what I thought were the other two bed bolts but as soon as I got them out I thought they weren't, and they weren't, they were the two bolts just ahead or behind maybe the back bed bolts that have to be accessed through the frame, I have to get a longer extension for my ratchet to get these last 2 out. I only got about half way though the swap, it'll be Saturday before I can get back to it and hopefully done. I wish swapping beds was as easy as on my Ranger was, 6 bolts from the top, disconnect taillights and disconnect fuel filler neck and pull it off. My arse is dragging this morning! Be watching your computers for questions I may run in to Saturday morning/afternoon. That stuff ain't no joke I spent 5 hours in a JY trying to get one off. Link to comment Share on other sites More sharing options...
mvusse Posted June 15, 2012 Share Posted June 15, 2012 Installed new starter. Again. Link to comment Share on other sites More sharing options...
87MJTIM Posted June 15, 2012 Share Posted June 15, 2012 I learned that if you pull out the radio, be careful re-installing it. I was going nuts trying to figure out why my fan stopped working. I knocked the power cord off the heater/AC control :doh: :mad: :oops: Link to comment Share on other sites More sharing options...
MancheKid86 Posted June 16, 2012 Share Posted June 16, 2012 installed bose speakers, fixed my oil pressure gauge, new drum, ordered new axle seals + bearing, will seal and do bearings next week :D Link to comment Share on other sites More sharing options...
RockMJ Posted June 17, 2012 Share Posted June 17, 2012 Got her a new friend! 01 4x4 Amber Fire XJ. Been cleaning it to my liking all day. here's a before pic 540 mile round trip after work Thursday to outside of Miami to buy it, turn around and be at work the next morning at 8. All the while in severe thunderstorms. Jeep ran like a champ though! RockMJ Link to comment Share on other sites More sharing options...
Zenobian_84 Posted June 21, 2012 Share Posted June 21, 2012 Got measurements done to add some striping to the truck. Slowly but surely..... :yes: Link to comment Share on other sites More sharing options...
Blue88Comanche Posted June 21, 2012 Share Posted June 21, 2012 Reattached my rear view mirror for the 6th time in the past year.... :fs1: Link to comment Share on other sites More sharing options...
Paul Bruchal Posted June 21, 2012 Share Posted June 21, 2012 Reattached my rear view mirror for the 6th time in the past year.... :fs1: My 2 sub woofers knock mine down. So i keep mine under the seat until the police :thumbsup: Link to comment Share on other sites More sharing options...
Blue88Comanche Posted June 22, 2012 Share Posted June 22, 2012 Reattached my rear view mirror for the 6th time in the past year.... :fs1: My 2 sub woofers knock mine down. So i keep mine under the seat until the police :thumbsup: I guess the heat of the summer got mine last year.. several times. i will be happy if i can get it to stay up Link to comment Share on other sites More sharing options...
mvusse Posted June 22, 2012 Share Posted June 22, 2012 Put the little tires back on. Link to comment Share on other sites More sharing options...
Paul Bruchal Posted June 23, 2012 Share Posted June 23, 2012 Getting 31" tires today. Fitting with no lift. Fenders are rusty so they will be cut...more. Ordered this today also: Its a roof rack because I have no bed. http://www.prolineracks.com/proline-gmr ... racks.html Link to comment Share on other sites More sharing options...
86custom Posted June 24, 2012 Share Posted June 24, 2012 Replaced my water pump and fan clutch. Replaced fan clutch with a cherokee one, I hope it wil work? Link to comment Share on other sites More sharing options...
88SGTSlaughter Posted June 24, 2012 Share Posted June 24, 2012 Removed bedliner for first time, everything was solid! Then Seen my battery was leaking, so I got a new one. Then I cut the bad spots out of the floor on the D/S :wrench: Link to comment Share on other sites More sharing options...
MiNi Beast Posted June 24, 2012 Share Posted June 24, 2012 installed a new, free oxygen sensor on the baby jeep. :yes: took me 5 mins. I love rust free Jeeps. Link to comment Share on other sites More sharing options...
88SGTSlaughter Posted June 25, 2012 Share Posted June 25, 2012 Finished my d/s floor! Link to comment Share on other sites More sharing options...
my86manche Posted June 25, 2012 Share Posted June 25, 2012 pushed it in a corner to sit for a little bit blew out the rear main seal and gotta clean the carb or something i can't figure it out yet :fs1: :fs1: :fs1: Link to comment Share on other sites More sharing options...
ComancheKid45 Posted June 25, 2012 Share Posted June 25, 2012 Got the pinion seal replaced on Walker, waiting on a diff cover and itll be back on the road (well atleast on the ground in the garage ;) ) Link to comment Share on other sites More sharing options...
88SGTSlaughter Posted June 26, 2012 Share Posted June 26, 2012 sprayed another coat of primer on the inside floor. Link to comment Share on other sites More sharing options...
MiNi Beast Posted June 26, 2012 Share Posted June 26, 2012 smashed up the rear drivers track bed corner took out light and ripped fender. So much for the baby jeep, time to build and beat it, going to turn it into a "Her Jeep" for the woman to drive and I'll still have my beast. :yes: Link to comment Share on other sites More sharing options...
relyt120 Posted June 26, 2012 Share Posted June 26, 2012 Got a quote for body work and paint...its only a matter of time now! :clapping: Link to comment Share on other sites More sharing options...
MiNi Beast Posted June 28, 2012 Share Posted June 28, 2012 Got a quote for body work and paint...its only a matter of time now! :clapping: so how much man, it'd give people a rough idea, like me. :brows: Link to comment Share on other sites More sharing options...
relyt120 Posted June 28, 2012 Share Posted June 28, 2012 so how much man, it'd give people a rough idea, like me. :brows: $1600 total, including some rust repair for the bed. pretty happy with it. :yes: Link to comment Share on other sites More sharing options...
TooTall Posted June 28, 2012 Share Posted June 28, 2012 bought a new fuel tank!!!and pump!!!! :fs1: Link to comment Share on other sites More sharing options...
MiNi Beast Posted June 28, 2012 Share Posted June 28, 2012 so how much man, it'd give people a rough idea, like me. :brows: $1600 total, including some rust repair for the bed. pretty happy with it. :yes: thats not to bad. cool thanks for sharing. :thumbsup: Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now