Jump to content

Bored throttle bodies


Recommended Posts

On 7/2/2018 at 3:29 PM, MeanLemons said:

I thought I did..

 

anyway. It’s $130 shipped. It’s $5 more than HO throttle bodies because it’s significantly more work. 

Whenever you ready to sell lmk, very interested on the renix one👌

Link to comment
Share on other sites

I m working on two cores now.  It’s basically finished but need to be sandblasted when I return to work on Monday (whole week off).

 

you can pre-pay for it or wait until I’m done. Either way works for me 

 

I also have a box of 5 cores being shipped my way.  So in next couple weeks I ll have those 5 done and ready. 

Link to comment
Share on other sites

On 7/3/2018 at 12:10 AM, saveevryjp1998 said:

Did you end up getting all the different tbs you needed/wanted? In other words are there any certain 1's you still need?

I have 5 of each now.  Thank you for the offer!   When I’m depleted of anything. You can be sure I ll be in touch. 

Link to comment
Share on other sites

25 minutes ago, TheDude said:

I'm still interested just a tad broke from an emergency job change..
Would you be interested in me bringing any cores I can easily scrounge up?


Sent from my iPhone using Tapatalk

Oh yes I can do that. 

Link to comment
Share on other sites

Is there any interest in bored 2.5L throttle bodies?  If so. What sizes?

 

60mm? 62mm?

 

keep in mind that stock 4.0L bodies are 60mm from the top and bottlenecks down to 56mm at the bottom.

 

stock 2.5L bodies are 48mm at the bottom. 

Link to comment
Share on other sites

  • 2 weeks later...
  • 2 weeks later...

Perhaps I should rephrase to better stimulate a response:

 

Are you guys getting any significant benefits from this?  What can one expect?  I wouldn't mind furthering my interest in buying one if the benefits/cost ratio works well.  

Link to comment
Share on other sites

  • 2 weeks later...
On 8/1/2018 at 7:29 AM, MeanLemons said:

Is there any interest in bored 2.5L throttle bodies?  If so. What sizes?

 

60mm? 62mm?

 

keep in mind that stock 4.0L bodies are 60mm from the top and bottlenecks down to 56mm at the bottom.

 

stock 2.5L bodies are 48mm at the bottom. 

I just saw this....

 

I’m down for it!!!!! Anything bigger what the 48mm is I’m sure it’ll give some oomph in the butt dyno 

Link to comment
Share on other sites

  • Pete M locked this topic
Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...