fiatslug87

See the end of this post.

Get a piece of wire and probe it, how far in does it go? Isn’t that one a stud with a nut?

For posterity https://www.hemmings.com/auction/1988-jeep-comanche-hawley-pa-158398/sold

It’s this one And the Hemmings auction https://www.hemmings.com/auction/1988-jeep-comanche-hawley-pa-158398/sold

Congrats and welcome, sounds like you know what you’re doing When you get a chance add it to the registry and someone will provide a build sheet. https://comancheclub.com/forum/32-1989/

Have you tried jumping the fuel pump ballast resistor?

What’s next?

Someone has the itch to go camping.

That's a CLEAN truck!! Looks like it's been repainted. Congrats.

While you’re in there make sure that steering box spacer is intact. It’s against the crossmember.

It looks like a 3/4” long Torx bolt and nut. Might be easier if you remove the skid plate.

I’ve got a set with the bolts. I’ll PM you.

Good to know. Thanks.

On eBay in Greeley, CO asking $10K OBO.

Sorry, I do not.

Interesting that this is a big ton, (G in the 4th position) but the build sheet says it has 3.07 gears.

I think it’s funny that UK spec has a 120mph speedo.

Eagerly awaiting your results.

Better haul some a$$!

Having and selling are two different things.

Didn’t realize I cut off the numbers.

What do you do with an extra NOS chrome MJ bumper (thanks G)? Put it on the MJ trailer of course!!! Also added a step bumper receiver in case I ever want to haul a basket. I made a couple of brackets out of 1/4" steel plate and attached them to the brackets on the trailer and the bumper. Outside view: Inside view: The trailer brackets are 42" apart while the bumper attachment points are 45" apart, so I used 1 1/4" zinc plated perforated square tube spacers on each side making up the 3" disparity (two 1 1/4" spacers and two 1/4" brackets = 3"), there's actually another spacer behind the one in the picture below for the lower rear bolt (it’s poking out in the above pic). It was fun doing this in 105°+ weather the last three days. Now back to the third brake light.

I have these, they fit very well and really keep the temps down. Amazon Coverking link

Should fit the 10 hole Eliminator wheels eBay link