fiatslug87

Ahh,

Rear bumper looks hideous

It's not showing up in their inventory search. I usually get emails when Comanches hit the Pick N Pull, nothing on this one. How is the steering column cover removed?

Hey you may be exceeding the LeMons $500 limit.

From what I've seen, only the metal handles had the gaskets. I purchased my '90 new, it had plastic handles and no gaskets, as did my other two. I've pulled metal ones, both black and chrome from the JY and they had gaskets.

Nice! Maybe you can dye it without messing up the graphics.

??? Where do you live

Where in northern CA was it?

I've learned exactly where to park each vehicle so they're right at the sidewalk but not hanging over The funny thing is ours is not the shortest driveway in the neighborhood.

Mine is short but fairly steep, it was fun pulling the engine with the truck in the garage and the hoist on the driveway. At least there's no snow or ice here.

............there you sit drinking beer for 1.5 hours while you recharge.

From what I remember, I put a flathead screwdriver between the vent and dash at the top, pressed down and out. There is a piece that can fall into the vent so be careful.

I still have mine from my formative years.

I don't have any recommendations but I've had a cheap corded Homelite one for 10 years and it's been a workhorse.

Too funny, that's 22 miles from my house and 18 miles from my work.

I've always read a front receiver hitch will not work with the skid plate. Maybe with some modifications it could work?

Received the OmixAda yesterday, looks identical to the new NTK/Bosch, 4 wires, steel body and resistance is 4.4 just like those two. Not sure if I'm going to try it out or just return it.

I do not think this is correct. The symbol is not the same as fog lights, it is the same as the high beam symbol. If you look at the factory wiring diagram in the above attached thread, the switch is only activated if the high beams are on, the switch is wired to the high beam circuit. Conversely, the fog lights turn off when the high beams are activated. These are the the fog and sport bar light switch panel symbols:

It must be the air flow is different now and the cable isn't being buffeted. You should probably zip tie the cable down better anyways. But, hey, a fix is a fix

Good work! I'm still waiting on the OmixAda O2 sensor, should be here tomorrow.

Don had written a DIY for an adjustable version.

That's a pretty weld

My sport bar switch is where the trans power/comfort switch is located. This thread has the installation instructions showing its placement.

Thanks, some day I will replace it with a modified Hurst Pistol Grip for a MOPAR.