JimiGibbs Posted January 26 Share Posted January 26 Can anyone recommend a source for the interior trim pin shown? Its for the upper door trim and back panel trim. I see lots of pictures on line but very hard to tell if they have the skinny post required to slide into the slot. THANKS Link to comment Share on other sites More sharing options...
JZLAJeep Posted January 26 Share Posted January 26 These look the like the same plugs used on the tailgate of an XJ. If so, the plugs have been discontinued and if you can find them, they are expensive. I was looking for Mopar 6504995AA. I ended up ordering some similar sized plugs from Amazon, putting the plug in a drill, and using a sanding block to modify the head and another file to cut the skinny post. It was messy and a pain, but it got the job done eventually. Link to what I used: https://rb.gy/v2ezwp Link to comment Share on other sites More sharing options...
Eagle_SX4 Posted January 26 Share Posted January 26 They may be the same or similar as the ones for the vent trim on the outside for the B pillars. I found some on Amazon that are a direct match for those. https://www.amazon.com/APPH5640-Plus-Parts-House-Compatible/dp/B01E8IY8K2 Link to comment Share on other sites More sharing options...
Gjeep Posted January 26 Share Posted January 26 They're different. Crown made/ makes the interior ones but they are hard to source. 34201545. It's termed a 'screw' but is not. Link to comment Share on other sites More sharing options...
Eagle_SX4 Posted January 26 Share Posted January 26 Got it I found an alternate part number that is supposed to be the same but a newer revision and they seem to be available but about $6 per clip. New part number 06504995AA. Edit: this is thread I meant to link both have the same alternate part number. Link to comment Share on other sites More sharing options...
fiatslug87 Posted January 26 Share Posted January 26 Summit has them. Edit: apparently they are not currently available, they go in and out of stock. Link to comment Share on other sites More sharing options...
89 MJ Posted January 26 Share Posted January 26 I would suspect AuVeCo probably makes them too, but I do not have a part number for them. Link to comment Share on other sites More sharing options...
JimiGibbs Posted January 26 Author Share Posted January 26 Thanks for all the replies.... Since replacements do not seem to be readily available I ended up trimming the neck of the fender pins (same diameter) so they fit in the slots on the back trim. Should work fine. Link to comment Share on other sites More sharing options...
garyweb3 Posted January 26 Share Posted January 26 I made my slots wider with a Dremel. Link to comment Share on other sites More sharing options...
ratrapp Posted January 27 Share Posted January 27 i just a bunch of these back in june from summit for 1.95 a piece.i see theyre currently unavailable now. Link to comment Share on other sites More sharing options...
Gjeep Posted January 27 Share Posted January 27 Just tracked it down AUVECO #12993. Some sites say this is a discontinued part; though I found on eBay. Looks like they changed the design a bit aftermarket... which may not be a bad thing/ easier to remove. https://www.ebay.com/itm/335742512541 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now