Jump to content

87MJTIM

Members
 View Profile  See their activity

  • Posts

    3039

  • Joined

  • Last visited

  • Days Won

    9

 Content Type 

Everything posted by 87MJTIM

  1. 87MJTIM
    I bought a new Fey bumper. Pretty easy to install. Old and new Backside of old New Installed
  2. 87MJTIM
    In CA, you need a Dr.'s prescription. However, in CO, it is now OTC.
  3. 87MJTIM
    Please forgive me if I repeat steps you have performed, but... Did you check the smaller fuses in the block: Turn/BU 20 amp, and the Haz/Stop 15 amp? Your picture shows a 20 amp in the Haz/Stop. If your highbeams stay on, then I will go back and check the turn signal switch in the steering column. It may be defective. All of the issues you mentioned run through that switch. I have found this electrical trouble shooting manual very helpful. http://comancheclub.com/topic/12083-electrical-manual/
  4. 87MJTIM
    What issues caused the failure?
  5. 87MJTIM
    I lost my brake lights previously. My hazard and turn signals worked, however. I replaced the turn/hazard switch harness and all was well. It runs down the steering column.
  6. 87MJTIM
    Do you have 3" lifts in stock currently? I was planning on giving the MJ a lift next year.
  7. 87MJTIM
    So, it sounds like it is just seasonal, not permanent.
  8. 87MJTIM
    Have they stopped all the MJ suspensions or just the 4.5"? I was concidering 3" lifts.
  9. 87MJTIM
    What's behind door #1. The headlight switch is the relay. The clock has two power feeds. When you turn on the lights, the over ride source kicks in. This override dimmed the illumination light on the clock and radio. Since the clock goes dark when you turn on the lights, I would replace that switch.
  10. 87MJTIM
    Year 1990 1-US (Country) J-Jeep USA (Manufacturer) 7-Truck (Type) F-4001-5000 GVW (GVRW) J-Cherokee or Comanche 4WD (Line) 6-Eliminator (Series) 6-Truck (Body) L-4.0 I-6 (Engine Type) 0-check digit L-1990 (Model Yr) L-Toledo #1 (Assembly Plant) Last six-serial #
  11. 87MJTIM
    Yes. Are you skinny? You'll need to be to get under there. Been there; done that; have the greasy t-shirt. The second time I raised the truck, let the front wheels hang down. Much easier!
  12. 87MJTIM
    If it just started with this tank of gas, have you considered water/cheap gas? Put in some gas addative and run out that tank.
  13. 87MJTIM
    Dejavu. Does the cigar lighter work? I just had the same issue. What Cruiser54 said. Replace the headlight switch relay. The dash lights, radio, clock and lighter all run through the relay.
  14. 87MJTIM
    My vote: U-joints. Just my $0.02 (that's US, not CA) ;)
  15. 87MJTIM
    4x4. I live in Maryland - The Peoples Republic of...
  16. 87MJTIM
    What is included with the "guts"?
  17. 87MJTIM
    Unfortunately, it is on a 90 xj. So the slave is internal.
  18. 87MJTIM
    Would the bell housing of a BA10 fit an AX15? or will I have to get the BH for the AX15?
  19. 87MJTIM

    Nice Try

    87MJTIM replied to Comanche County's topic in The Pub

    You may have seen this picture of the Cherokee trying to cross the boarder from Mexico. http://news.msn.com/us/smugglers-try-driving-over-us-border-fence-get-stuck
  20. 87MJTIM
    I am not able to PM you. What am I doing wrong?!?!
  21. 87MJTIM
    Are the tans still available? Can you send them east to MD - 21774?
  22. 87MJTIM
    Are fuse blocks compatable across years? Mine is an '87. Will later years be the same?
  23. 87MJTIM
    Try one inch of black electrical tape. Cover over the offending light. Problem solved. :laughin:
  24. 87MJTIM
    Does the whole MJ shake up and down? or does it shake like the engine is missing? If the whole MJ shakes, I would recommend looking at the U-joints. I had and '89 XJ that did that. During exceleration the XJ would shake violently. I would pull over and stop, (let my heart rate get back to normal), then drive on. It wouldn't happen again for awhile. Just my $0.02.
  25. 87MJTIM
    I want the pedestal, though. Mine are rusting at the bolts.
×
×
  • Create New...