89 MJ

Put an AX15 in your KJ manual for life.

Da you have a way to test these? I don’t do a lot of trail riding, but I do a lot of on road stuff.

I think it may be time to start a build thread.

4cyl auto, don’t those have low rear gears?

Oh wow! I’m just north of La Crosse in Holmen. I have another MJ buddy who is finishing his. We will need to get together some time! Here is a pic of mine in case you have seen it around.

Are you in WI? If so, where? I am near La Crosse and @500 MJ is near Madison.

We want as many pics as possible.

Reproduction brackets. Repop is just a shorter word. If you want his brackets, they will be in the classifieds under vendors.

It should fit. @krustyballer16 would probably know for sure. He even makes repop seat brackets if you needed some.

I would. To me, if it is a solid axle Jeep, it gets the wave. Unless it has angry eyes. Then it doesn’t.

I may as well kiss it good bye then. I float gears all the time. And launch hard.

Nope SporTruck. I know a guy who does vinyl wraps though. He could make me some stickers.

I would like everyone to checkout what @eaglescout526has done to his truck! You can see what he has done with the last 3 pics in his MJotM section. I must say, I am now contemplating getting stripes for mine.

A glorified shelf while it is stored.

Do you have a link to it?

Me too!

The 1st MJOTM of the New Decade: EvilMJ's 1989 Evil MJ!!! YEAR/MODEL: 1989 Jeep Comanche - 162k ENGINE/PERFORMANCE: 4.0L inline rebuilt at 145k DRIVETRAIN: 4.10 gears front & rear AX15 transmission w/ 115k on it at 145k Rebuilt 231 transfer case HD slip-yoke eliminator & Novak cable shifter Rebuilt front axle - new bearings, seals, U-joints, & ball joints Tru-track locker in front axle Clayton Offroad front truss Carolina Driveline rear driveshaft Rebuilt Ford 8.8" rear w/ disc brakes, new calipers, rotors, lines, etc. New clutch, flywheel, master & slave, pressure plate, lines, & bushing ELECTRICAL/IGNITION: New coil wires, distributor, and ignition module SUSPENSION/STEERING: Clayton Offroad 3-link long arm kit, trackbar, drop bracket, dropped pitman arm, & steering stabilizer HD steering linkage (draglink & tie rods) and diff covers New coil springs w/ adjustable spacers Bilstein shocks INTERIOR: Gentex auto dimming mirror w/ temp & compass JW Speakers BRAKES: Rear Disc LIGHTING: LED lights all around including A-pillars EXTERIOR: Custom bobbed bed, bumpers, sliders, 35" spare tire carrier, winch mounts, etc. WHEELS/TIRES: 5 Procomp 15s with 35x12.50R15 Pitbull Rockers MISCELLANEOUS: New fuel lines, pump, tank, & filter Spectre cowl intake and filter New exhaust, radiator, thermostat, Congratulations!!!! The bed on your truck is sweet!

When did that happen?

Make MJ parts. Continue making you current parts but also make floors, rockers, bedside patches, tailgates, bumpers. You clearly have the skill and there is the need. But it it might not pay very well.

Oh my gosh, I haven't updated this since October! Not much has happened. It is currently in storage. Hopefully I'll be able to track down the miss in the next few weeks.

I’m building one now because I saw this.

I thought you were indirectly asking for help. My bad.

Just so you know, this thread was last commented on 7 years ago.

Is that @Pirate_Staz and his MJ?