sinkrun

Also talk to your bank if doing a out of area sale / ship. And the most important thing is that the money is CLEARED and ok by your bank before it ships anywhere.

Yep as soon as you try to order its out of stock.

I can tell you there is many missed sales with this text only crap. I do not text there is no cell service were I live I am not a scammer and just don't understand why people only text but refuse emails. Theres been many item I would have bout from people if they could have answered a email or phone call.

http://www.ebay.com/itm/OEM-Jeep-4-0-Stroker-Cam-Button-Bolt-Spring-Pin-and-Washer-MADE-IN-THE-USA-/171950819454?hash=item280911487e:g:lqoAAOSwPhdVJTme&vxp=mtr

RIP Peter.

Was just looking the rotors over and f`ing made in china also, had I known that I would have just bought another junk set at advaced again!

Got a great deal on Brembo rotors from ebay on a closeout for the 01 Cherokee. It does not look like brembo sells pads for the Cherokee anymore. Does anyone have any suggestions on what pads to run with these for best results. I always wanted to try Brembos tired of the junk rotors warping these were not much more than cheap china rotors so I am hoping for the best.

I might sell mine (have to give it some thought) but have no idea how to ship it ,any suggestions? Also I have more money in mine however it is not damaged. PM me akula maybe we can work something out.

If it were the pass side I would be all over it! I have seen a few of these over the years and there all the drivers side including the one in my attic.

Any advice on reinstalling the shaft? I had a local driveshaft shop rebuild it so that parts done.

Got it you do have to beat the crap out of it, 3 pound hammer beating on the slide hammer did it took good 10mins.

Tried slide hammer still nothing. This is a trac loc does this make any difference? Hate to pull the cover if not needed.

Just now working on this got the retainer bolts out shaft will not come out any suggestions?

I am out can't find them sorry!

I should have them will look at lunch time there yours for the cost of shipping.

Very nice work where are you located in Pa.?

I am having trouble finding kit for mine as I want to replace the bearing, seal and retainers all the listings on ebay are for newer 44`s or older 35`s some say they interchange?

I would also be interested in this as I am getting ready to the same thing. And yes that seems pricey.

Wow thats easy no need to get into the diff cover thanks for the info.

Can not find a clear answer on how to remove the shafts from the rear d44 in a 89 Comanche so I can have the bearings and seals replaced. Local shop said if I get them out 20.00 a side to remove replace with new if I buy the parts.

Allen Wrench?

April fools?

That should be a good one, as long as the oil pressures good I would go for it. I cracked and cooked A 2001 engine at 150000 put a used head on it as I didnt have much money at the time. That same jeep is sitting here with 227,000 on the same original block with used head still runs strong but it is getting noisy. I have another 2001 I bought knowing it was cracked had 85000 miles pulled the head off and the pistons were melted that one got a new engine.

Is the good oil pressure good? What head year did he use?

Somewhere once I found a chart with mile/falure comparison rates can't find it now. It was and is HIGH if theres any brown in the antifreeze you most likely have a problem don't assume its just dirty. If its clean priced right get it put a different year head on it and be done.