jbhill

havnt really seen much info bout the 2.5 on here. what transmissions bolt the 2.5? is it a 60 degree chebby bolt pattern? ive ben contemplating swaping the 327 SBC in mine to once since exhaust clearance in mine will be ultra tight, if not impossible.

haha me 2! i would love a carb'd 2.5 with an auto to throw in here instead of the 327...then i can get crackin!

so i guess the question is were DOESNT it come through in an MJ lol.

only trucks ive ridden that rode horrible were extremly slammed,stiff but worked. 83-97 ranger coils should drop it a couple inches since XJ/MJ springs lift a ranger a couple inches lol. you will prob have to cut the bump stop mount down.anything past that much in the front and rear and you ahve to worry about wheel offset. i read the instructions on my lift kit backwards and thats how it turned out :D :rotfl2:

my guess is wind sheild or rear window gasket area.baby powder will help track em down. also check grommets on the firewall.

lol serious?

yup its got airbags, the wheels are 17x8 boyd derringers. 245/35 tire.

measure the angle of the output flange on the trans/tcase(usually around -2 or -3) raer pinion should be around +2 or +3 a degree wheel is your friend.

i always wash plastic stuff with dish soap and a grey scuff pad if I'm going to paint it. cleans and lightly sands it. b4 i spray on plastic adhesion promotor, i clean it with wax and grease remover.

i like the tan better lol.

make a new front nose for your riding lawn mower :yes:

uh, no, they are not, one has 3.73s and the other has 4.10s meaning there the same housing not gear sets....

my guess would be a stuck relay.

zero. ive never driven mine in the 3 years ive owned it...lol

make sure it isnt leaking out of the master all over your fuse block...

i wanted to see if the chrome ones would fit with out mods and they do. yea i read the instructions backwards lol!

fyi those are the same rear ends.

i would love to trade my almost mint red ones for ones with good chrome, specially for treefiddy lol.

they just snap into the cab with plastci clips.

ditto on the calling, i need to come steal my back window!

yea but vaseline is easier to clean up and cheaper lol.

put em in the glove box? the cables should still reach...

darker silver color was the factory color. and this was free lol. its just all the left over silvers from repair jobs mixed in a gallon can lol.

dana 35 rear? did you check all the bolts to see if everyhing is tight with a socket not just looking at them, if the gas tank isnt about to fall out?

y didnt u grab all that fresh meat? lol. am i the only one that noticed the one with the roll bar is an 86 X model?