FxRacing282

hmmm i woiuld have just poured it in there :wrench:

it oculd possibly be a faulty heater in the O2 sensor. an O2 sensor needs to be like 1000F or something rediclous like that. just might not be heating up fast enough

oh dang there are some nice manches floating around in my neck of the woods but it wouldnt be worth the $300 to drive it back... well accually it may be

does that mean you won't do one on my K10?? pleasssseee :brows:

where you located?

Any supplier that tells me that my MJ front end is somehow different than an XJ front end is no longer my supplier. :roll: amen to that

yeah but why bust your balls in the winter? you can do it in the spring when its nice out and the driveway/concrete isnt wet/cold

dude... use the mystery oil in your oil. the stuff has worked wondors for me and others.... then if it dosent stop it id worryt about replacing the seal. why spend the money and time to change something when all you may have to do is spend $4.99 and 2 minutes putting it in?

http://4wheeldrive.about.com/gi/dynamic ... /lift.html

if you don't have a welder a ball-peen hammer, rivits and a little bondo will work. that would be better then foam anyday

and when moisture gets in the foam will act as a sponge and will take forever to dry out, thus causeing more rust in the long run. if you have a rust hole, your best bet is to mig weld some new sheetmetal ondo whatever it is thats rusted. of course cut away, sand and prime before you weld

hello everyone.. well this inst for Comanches specifically but...i wondoring if anyone is 100% sure what size the axle housing diameter is on a Corperate 10 bolt with the 8.5'' ring gear. it was used since '81 to today. i think its three inches but i don't have a micrometer to check. any help would be appreciated

hop to it

nah he should be alright with a slip yoke

to convert to the AX or the NV wouldnt you need a new bell housing? or do they both have internal slave cylinders?

yeah 4.5'' will work fine. i assume your going to get a new leaf pack instead of doing an SOA swap?

wow looks like jesus. also looks like youve been puddle jumping

Electric... I don't pay for it, so it's all good. Most places that people actually care about not going broke have a wood stove to at least cut down the electric/gas bill. Here I pay flat rate on my rent, so it doesn't matter. I also plug my dodge in because my coolant mix is borderline at -40. That and diesels HATE cold. Like I said, I've seen a few wrecked blocks. It only takes a couple degrees the wrong way to cause major problems. lucky you i got a space heater in my room now, keeps it at about 66F like 22C or something along those numbers.

they stink. i call them street terrains. if you want some off road tire and you want BFG's then get the mud terrains.

WAHOO GO GENERAL MOTORS

i bought a "el cheapo" shifter knop and ive glud the plastic thing to the threads like 9 times hoping it would eventually stick :headpop: . i don't even have a jeep and my truck hates me :cry:

-20C is -4F so yeah thats pretty cold. i do know how you feel but just not for the -40. what do yall use to heat your house?

;) How's about the negative 30's? I grew up north of you in PEI.....you don't get temps as cold as we get out here, but you get the wind which we don;t....all evens out. PEI?

oh trust me we know cold. zero degrees dosent faze me. its just a little chilly for now. when it gets into the negative teens its cold