ISO cylinder head

[Strokermjcomanche]

I understand that this should/ might also be in wanted.

 

I’m looking for a 0630 or 7120 head , Just as long as it has the Threaded sensor hole at the rear of the head . It doesn’t  need to be anything real special, just something I don’t have to worry about for years to come. I had mine rebuilt several years ago along with the block being machined and it only cost me $500, now any reputable head is $500 + . Just seeing if somebody had another idea out there that might be cheaper and good . 
 

The local machinist is about three or four weeks out, and I’m not gonna have that much time to get this done . Not to mention I don’t have a used cylinder head to be rebuilt in the first place. The engine didn’t come with the head. Thanks in advance everyone.

[neohic]

Let me check…

[eaglescout526]

Damn. AMC had quite a few. Ugh if only I could’ve bought their entire inventory. 

[MiNi Beast]

So are you wanting one to rebuild or would you like one ready ? 

[87MJTIM]

I have a Renix head that is collecting dust (and possibly rust).  It is fully disassembled.  I needs to be rebuilt.  The PO told me it was magnifluxed with not cracks.  But it is here in MD (just a stones through off I-70).

[Strokermjcomanche]

Thanks to everyone that replied. Some issues came up and I’m not doing anything with this right now, as a matter fact not doing anything right now. Again thanks