Jump to content

Recommended Posts

Posted

Stalled my truck and afterwards the starter would just click when turning the key. No crank whatsoever. I had just replaced my battery and verified my alternator was working. I had bypassed the ballast resistor and it had started fine twice before that. I bought a new starter in case this one is just bad, but how could stalling make a starter die? Is it just stuck or completely dead?

Posted
1 hour ago, yungupgrade said:

Is it just stuck or completely dead?

 

Make sure all your heavy cables make good clean contact. Battery(+) to Solenoid, Solenoid to Starter and Engine Block to Battery(-). Check Starter bolts, make sure there not loose.

Posted
On 9/18/2023 at 7:56 AM, cruiser54 said:

Is your starter covered in engine oil by chance?

Not sure if this qualifies as "covered" but this is what it looked like.

IMG-3237.jpg

IMG-3238.jpg

IMG-3239.jpg

IMG-3240.jpg

Posted

The hammer trick did not work. Additionally the wire which runs from the positive relay was connected using a crimp connector. Pretty awful. Turns out the replacement unit from amazon does not fit my truck. Are there any starters on rock auto that are good?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...