97+ Dash in a Renix truck

[Squilly]

I want to put the 97+ dash in my truck, but I don’t want to convert to OBD ll. Has anyone done this or know a way to retain the Renix engine management and gauges while swapping the interior? I thought about using a custom gauge cluster in a blank template that fits the newer dash, but I wasn’t sure which gauges work with Renix. 
 

ideally I just want to update the interior and allow the ability to run a double din radio with the already existing center dash swap that’s out there. 
 

Any ideas would be helpful! 

[jdog]

You could always move the heater switch to the radio slot and put the double din below.  I have not heard of people using just the dash, it's usually a full swap but I bet it could be done. But it will probably take some custom gauges.

[boxyjeep]

Honestly better off doing the complete swap.  You can use the TJ gauge surround for aftermarket gauges and keep Renix, but you will end up splicing a ton for light controls, HVAC, etc. and in the end be better off just doing a direct swap.

[oldmanche]

If all you want is a double din radio, I've seen a members here do that.