BlackBeast

Thanks, hope to get installing it this weekend if I have all the stuff I need and time! 17s on the rims and my tires are to good not to wear out now,so when I find a good deal on a set of tires or wear the 15's down I'm swapping!

I'm thinking it's a hot wire... That's what I figured but will double check to make sure.. I haven't looked to deeply at it. I just know I have to run it diff to make it work the way I intend to ha e it work. Thx,Jeep Driver.You where right, went back and checked.

Lol, yep Kickinmule, I take that wire to another ground wire and bypass it so I can have it on whenever . I don't plan on watching TV in drive but someone on passenger side might want too.

I will.

My opinion is u need a frame for plowing, not a unibody... but I have seen the NJ snow project and he seems to make it work!.

Beutimous!

Don't blame you!

Yes the screen goes below bc it would not work with a upright screen bc of ledge on dash.. This unit has a detachable screen and does not retract in unit. I like the reveiws on it. I also like the structure of unit. I can't wait to get it in! YES I LOVE MY WHEELS! THANKS!

Looking for ideas? Want to build a custom rear panel behind seats on back of cab . Anybody have picts? My original is gone and i thought about making one. Thanks.

You lost pressure.. bad master or slave. Like I said,check fluid and go from there. Good luck! You will find its a simple system.

Where did you get that ambient temp display at??? I would like 1 like that in my 91.

And wheels are here to look at for now. Oh well at least I got a dang good deal on them!

My Tunes just arrived! I will hope to get installed this weekend. pict is upside down.

Motor might me drawing to many amps??could have a short? Or resistor is shot and caused a short..I would check your voltage from blower motor first to see what it's pulling as far as amps. My thoughts.

Heck, check the fluid and fill if needed and pump the clutch. .it should build resistance. Yes you will have a bleeder also if you need to use it,I didn't on my internal. Also make sure ur master cylinder isn't leaking inside your cab..

So did you find out what was your prob? Did you pull dizzy loose and look..man that bites!!!!

I have rusty lift and I really don't like it personally. It's not terrible but to each there own..I also did go up a few inches higher tho. POST PICTS WHEN YA can!

Old man emu ..if I was wanting a little with a nice all around drive.

Tell me about it. Freezing. . You guys got the snow ,this round . I finally finished my headliner on my 89 tho. Hope all is well!

Rubicon is nice but $$$ or you can mix it up and make your own .

Looks nice!

Ur-welcome,if you happen to take this project and have questions I will do my best to help ya out!

Thanks it was a experience ,but worth it, insulated with regular duct insulation. I had some around so didn't cost anything. IT was a little messy and a pain but works. You might want to order some actual car insulation or sound deadening. Temp sensor is not here yet but I will be getting it from the gm shop most likely or online ,if I kind find it . B pillar lights will be Euramtec.. most likely but I haven't got that far yet. Xj visors are from a 2000 but I would think most 97-01 would work...I was very happy with how the contour of console worked out.. I did make changes and I think they worked out great!

Nice!

I like the redneck part! Great job !