derjeager Posted December 11, 2006 Posted December 11, 2006 I am working on an 86 jeep comanche i am doing an engine and trans swap it has a 2.8 and a standard trans. I am putting a 4.0 and an auto in it any wiring harness info would be helpful.
minydigger Posted December 11, 2006 Posted December 11, 2006 I recently did this same swap, I used the entire harness from my donor XJ it made the wiring part cake.
derjeager Posted December 11, 2006 Author Posted December 11, 2006 is it just plug it in andgo or what
sinnaevd Posted December 11, 2006 Posted December 11, 2006 the wiring should be. grab an xj parts doner, swap in the entire dash. it should all bolt in. your motor mounts and tranny skid will be different but the dash should fit just the same as it owuld in any other manche
pingpong Posted December 11, 2006 Posted December 11, 2006 If you were closer i would lewt you pull my running motor out of Pong so I could start my engine swap
derjeager Posted December 12, 2006 Author Posted December 12, 2006 thanx for the offer but i have most of the parts
Landoloops Posted January 29, 2007 Posted January 29, 2007 qustion for sinnaevd or any one else what did you do for motor mounts?
wombat Posted January 29, 2007 Posted January 29, 2007 it would be easier and probably cheaper to drop in a 350...
Pete M Posted January 29, 2007 Posted January 29, 2007 Dunno 'bout that. The 350 has its own set of complications that need to be overcome. Neither option is "easy" by any stretch of the imagination. At least the 4.0 stuff will bolt in (most of it anyway) if you get a complete donor Jeep. Trying to piece it together with junkyard parts could be a nightmare.
pingpong Posted January 29, 2007 Posted January 29, 2007 Doing a 4.3 swap, or a 350 swap difficulty depends on what kind of setup you are going to run. A propane setup, you only need like 4 circuits.... fuel injenction you need lots more.
minydigger Posted January 29, 2007 Posted January 29, 2007 The motor mount brackets from the donor XJ will bolt right onto the MJ frame rails. at least they did on mine. It was the easiest engine swap I have ever done to date.
Eagle Posted January 30, 2007 Posted January 30, 2007 The motor mount brackets from the donor XJ will bolt right onto the MJ frame rails. at least they did on mine. It was the easiest engine swap I have ever done to date. What was your experience ragarding clearance at the firewall? I've seen some people say they had to do a "little bit" of reshaping with a hammer, others have said they had to cut out and reform the firewall ... and then there are those (mostly who have apparently never compared the two years) who steadfastly maintain that the early and late firewalls are identical. Did yours need any "gentle persuasion"?
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now