Jump to content

Tempreture sender


Recommended Posts

Need help

my comanche 1988 

temperuter gauge not work , and wire of sender 12v ! This normal?? I think no .

i cheked conction between gauge and sensor but found tow wire output from geuge one wire from sensor another wire i don't know where to go . 

Whats problem? I need wiring daigram .

 

85B6B9E9-D2E8-422B-8E57-43DAE156DBC7.jpeg

987BE611-31C6-4713-90FC-17BE967BA0F8.jpeg

F566DCBD-2724-4078-8554-0F833091C7A6.jpeg

E065A17A-132C-448B-923A-41D6125218B2.jpeg

DFEAE73E-60B2-49F0-B4E9-A720FC443707.jpeg

Link to comment
Share on other sites

The wire for the sender comes from the gauge, and is supposed to have 12v. The sender is a variable resistor that grounds to the engine block. If you pull the connector off the gauge should read zero, and if you ground it, it should peg the gauge to the top. If that checks out, the issue is between the connector and ground. Probably the sender. Don’t use any thread sealer or plumbing tape on the sender threads or it won’t work.

Link to comment
Share on other sites

19 hours ago, gogmorgo said:

The wire for the sender comes from the gauge, and is supposed to have 12v. The sender is a variable resistor that grounds to the engine block. If you pull the connector off the gauge should read zero, and if you ground it, it should peg the gauge to the top. If that checks out, the issue is between the connector and ground. Probably the sender. Don’t use any thread sealer or plumbing tape on the sender threads or it won’t work.

Ok

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...