Lee21490 Posted March 26, 2015 Share Posted March 26, 2015 Can not for the life of me find a replacment pin for an '86 comanche Mine must have snapped or something, Because i got a bunch of slack in the bottom hinge & My door won't close properly without throwing it as hard as i can. If anyone has a part # or a link, That would be great! Also; whats the easiest way to remove the pin? Bfh? /edit found the door pin after a bunch of googling. Whats the easiest way to get the old one out? Hammer? Or drill? Any tips? Link to comment Share on other sites More sharing options...
HOrnbrod Posted March 26, 2015 Share Posted March 26, 2015 Part number is 55000765. You can get it HERE. It's a split rolled pin, heat and drive out from the bottom using the correct size drift punch and a BFH. Link to comment Share on other sites More sharing options...
Dillithium Posted March 26, 2015 Share Posted March 26, 2015 When I swapped my doors I used a hammer and a drift punch, no heat. But my jeep came from California, so you may need heat as Hornbrod suggested. Link to comment Share on other sites More sharing options...
Blue XJ Posted March 27, 2015 Share Posted March 27, 2015 Check to make sure it's the pin. The hinge could have pulled off of the body as well. Link to comment Share on other sites More sharing options...
mjeff87 Posted March 27, 2015 Share Posted March 27, 2015 Remove the old one with a pair of channel locks, the jaws have just enough of an offset if held at the right angle to drive the pin out the top with the bottom jaw while placing the upper jaw on the pin housing. Installation is reverse of removal. Easy peasy. Jeff Link to comment Share on other sites More sharing options...
Lee21490 Posted March 31, 2015 Author Share Posted March 31, 2015 Well i got my pins in the mail today, Ended up having to remove the door to get a good hammer swing... Beat on it for a good 2 hours while heating it, did not budge a single mm... seems like the pin is fine and the hole on the body side of the hinge is ground out.. Not sure where to go from here.. Door sags a good 3~ inches currently and i can barely close it. Cut off the hinge from the body & weld on a new one? Is there a way to use the newer style hinges on our early mj's? :/ Link to comment Share on other sites More sharing options...
Jeep Driver Posted March 31, 2015 Share Posted March 31, 2015 Drill out the old pin and install a new over sized pin. Link to comment Share on other sites More sharing options...
Jeep Driver Posted March 31, 2015 Share Posted March 31, 2015 Did you use a roll pin punch? Link to comment Share on other sites More sharing options...
Jeep Driver Posted March 31, 2015 Share Posted March 31, 2015 Take a cheap air hammer bit, cut the end off so you have a blunt hammer bit. Use rubber hose to connect the bit to the hammer end of the punch. Use the air hammer to loosen or drive the pin out......short burps. You'd be surprised with a small amount of vibration will do to stuck pin.....ball joints.......etc... You'll have to hold the punch and bit together with your hand....all the fuel hose will do is keep the bit from running off the punch. Link to comment Share on other sites More sharing options...
Wesleypipesyo Posted March 31, 2015 Share Posted March 31, 2015 Why do you need s door? Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now