grabber

Well I have injector signal durning crank, no arking from wires or coil, Going to check timing in the am, can't remember if I did it, and also have a different coil pack to go in.

Its a 86 custom, long bed with a 2.5 l

I also have a new coil, cap and rotor

Open ECU to figure pin out and have starter signal on pin 29, noid light should be in today, Have battery @ injector. So I beleive Its a different signal nissing now to get prime oulce, But I'm clue less.

did work out it last night, storms. but it looks like pin 29, start signal, ECU pin not right. maybe tonight

Found out that the starter switch has a dk grn to the starter sol, it should have a grn/whit to pin 29 of the ECU for the start signal. Their is no grn/wht connection. aslo can't id pin 29 of the ECU the 35 pin out has a mark on pin 2 but the unused pins on 9 and 20 don't match.

It has nothing to do with the fuel, Order a light to check the injector, I believe I'm missing a input to the ECU for the prime pulse, pulled fuel relay and it died OK, Pull Throttle Position, NO Change, ran. Read on JeepForum the the fuel pump wiring hooked up backwards will stop it from starting, but will run after a shot of starter fuild. :huh???: anybody heard of that?

Before you have a Idea please read. I have replaced the following parts, Crank sensor has nothing to do with starting, Water temp to ECU, Air Temp, Injector, Starter SW has signal to ECU pin 29, ECU, Throddle Position sensor is set per manual. fuel pump and filter replaced, fuel pump bypassed fuel relay ( runs full time and have good pressure at TBI) Fuel relay show it connect a signal to the Injuctor will check it today. Not sure all Signal need to ECU to get Injector to Prime. But if I give a shot of starter fuel It will start and run.

I did a Rusty's Long arm, No instructions with the kit, Call them about the bracket on the frame, just unbolt it,,, WRONG.. You have to cut it out, Its well built. It just a lot of cutting to get the bracket off

At 6 " yyou well need to do a long arm kit, Did one myself, alot of work, no instructions, but looks good

Where In Tn, I live in Millington

I have a set on my MJ 33*12.5-15 Great tire

EBAY has a MJ replacement headliner any color for 135 shipped, I got one and looks great , problem over

Installing long arms Came with No instruction , alot Frame work

Live in Memphis, Have two MJ's 86 & 89