Jackrabbit41

I have lift coils so the ZJ ones wouldn't work

For sure! I love it. I actually ordered the ball but they sent me the T but I like it

I think like 1.5-2.5 or some thing

I want to get rid of the raked look. I want my truck level. what spacers are the best? I only need an inch or so.

Man o man am I glad I got that shifter. Best modification ever! Hands down! I love this thing. Shifts so good, throw is so short and looks amazing! I made a YouTube video of the install (it wasn't easy with my set up). My OTK steering came today so I'll put that in soon too. Sent from my iPhone using Tapatalk

Total waste of money don't do it

Ive replaced 3 slaves and always forget to NOT cut of the straps lol. Then its a huge PITA to get her in.

Just dropped like all my money on a hurst short throw shifter and over the knuckle steering! I can never save my money very well, but i can't wait for this shifter. Its going to be awesome.

Just get rubicon express CAD drop brackets from Amazon and you'll be dandy

I have about a 6 inch and I went a few months on stock control arms with control arm brackets. Never had any problems. Just switched over so o didn't have to worry about breaking them

Is there more then 1 flasher?

Blinkers aren't flashing. Replaced flasher. Didn't do anything. They work but don't flash. The hazards flash just fine. Flasher wires are solid. What do I check Sent from my iPhone using Tapatalk

Thanks

Get the pre bled kit from Napa or O'Reillys. 4 bolts and it's in

Finally building a rear bumper! Sent from my iPhone using Tapatalk

My truck came with these rims and I've always wanted center caps. Anyone have any idea what they are and what caps will work for me? Thanks y'all Same rims in the different pics. Just different stages of my build Sent from my iPhone using Tapatalk

Dope bro

Could be wrong wheel bearings. I had that problem and my rotors were rubbing on the upper ball joint arm thing and grooving them. I couldn't move

I got stock steering with 5.5 inches of lift and 33s. I go wheelin every so often and never have had any problems on or off road

I fixed the fender and it turned out pretty good. Didn't take long either Sent from my iPhone using Tapatalk

So found this Datsun near by and I really want to flip it and try to earn some cash. http://seattle.craigslist.org/see/cto/5671747126.html Needs fuel pump, fuel lines and a slave cylinder. I talked to the guy and he says that he can show me it runs but it won't run for long because no fuel pump. He also says he'd give it to me for 600$. 80,000 miles so I bet the motors fine. He's about 3 hours away so I'd have to borrow my dads Silverado and u haul trailer it home. Do y'all think it's worth it? I'd love to make a few extra bucks and have fun working on another car at the same time. Never flipped a car but I have all the tools to do it. He also says interior is perfect except for a rip in the dash

The po put in my weird some lights and had a weird ground wire going to the fuse box. I just unplugged it and put it back in then the lights started workin lol.

Last September I pulled out my carpet and cut out most of the foam backing material up the fire wall. Road noise increased but it wasn't terrible. My jeep leaks a little so I didn't want it getting trapped in with carpet. I went until about a month ago when I bed lined my floor boards with Herculiner. It helped with heat. A lot of heat off the tranny comes through the floor board but it's not to bad. I'd recommend Herculiner