Trapn6.0

Definitely like those for an option better. Are you using fuel rated hose?

Have you used these?

I like going the cheaper route. Any more info on those?

When it comes to axle vents do all of you just extend all of them or has anyone used the creeper breather kit.

Looks like it would make a nice trial run for my project.

How deep is deep? Lol

Updates?

Update? Or more pics. Not to hijack but how many diesel mjs were produced?

Where is 7 mile? Any info on iut. I'd be interested in an overnight run. Should be up and running by then.

I might have missed but what gear ratio are you running?

100 percent agree. Can't trust people these days and you don't know what level of stupid their capable of. Move on and learn.

Not much of an update but refreshed my grounds and beefed up my battery cables. Upgraded my headlight harness and I must say just doing that alone made the lights so much brighter. Also new valve cover gasket the nice blue one and while I was in there I did cruisers tip on trimming down the breather flutes.

This hole correct

Awesome that puts my mind at ease

With not having a bed close at hand do you all think the front mounts will still work or will I need to do a little fab work.

Actually now that I look closer at the front mounts by the cab mine look to be altered.pay no attention to my bars holding up my fuel tank.lol

Those pics are exactly what I needed. Trying to see what has been removed or added when they put in my utility need. This is what it looks like. Not sure I'd a long bed will bolt back on. This was the spot I was worried about.

Does anyone have a picture of a long bed unibody with the bed removed? Specifically the section behind the rear spring perches.

What way 2 states?

Awesome thanks everyone.

1990 jeep comanche 4.0 Ax15 D30 front D35 rear Current state almost on the road. Vin describes it as a 3 speed column shift.

Its a 90 4.0. Non ac. I couldn't find any open connectors.

Found it just wound up under the fuse panel.

Could someone tell from the pic what this connector goes to. Passenger side.Red and black wires in second pic.

Yea that's a good idea. Once I finalize everything ill go over the leaf.