asm4mcc Posted March 4, 2010 Posted March 4, 2010 89 mj swaping from at to mt i got the new flywheel can i use the same bolts bolts or they goin to be longer and are the starters the same
jimoshel Posted March 4, 2010 Posted March 4, 2010 The starter will work just fine. Auto FW bolts will usually be shorter than stanard FW bolts but not always.If you have the bolts from both then compare them. Anyway flywheel bolts stretch when torqued properly and should be replaced.
asm4mcc Posted March 5, 2010 Author Posted March 5, 2010 is there any where i can fine torque specs for:flywheel bolts ,pressure plate things like that
rcturgeon Posted March 5, 2010 Posted March 5, 2010 Well I use a Haynes manual, they're usually pretty good in my opinion and they always give good tips and tricks just to make it easier. but anyways the torque for the flywheel/ driveplate bolts are 105ft-lbs hope that helps
mjeff87 Posted March 5, 2010 Posted March 5, 2010 MT flywheel bolts are longer than AT flexplate bolts....beender, donedat.....I reused an old set I had with an extra 10 lb/ft of torque and plenty of red locktite. So far, so good. Jeff
mfpdm Posted March 5, 2010 Posted March 5, 2010 MT flywheel bolts are longer than AT flexplate bolts....beender, donedat.....I reused an old set I had with an extra 10 lb/ft of torque and plenty of red locktite. So far, so good. Jeff How did you hold the crank while tighting the bolts down? :popcorn:
-600JeepMJ Posted March 5, 2010 Posted March 5, 2010 :agree: How did you hold the crank while tighten the bolts down? when I put the flywheel on my 86 XJ I jammed a very big flat tip screw drive between the flywheel and the engine stand.
mjeff87 Posted March 5, 2010 Posted March 5, 2010 similar......I used a large prybar with an angled head. Put the tip into one of the teeth on the flywheel, reinstalled one of the side bellhousing bolts and wedged the bar. Jeff
mjeff87 Posted March 5, 2010 Posted March 5, 2010 they are not a regular hex head bolt.......Advance Auto has them (maybe not in stock but can PDQ them in a day or so): http://shop.advanceautoparts.com/webapp ... -with-9-10"-(22-86-mm)-Length-and-19-100-(4-83-mm)-Head-Dorman_22142711-P_N3352A_P|GRP2060____ edit: I can't get the page link to copy correctly.......go to AA website and search for "flywheel" they will come up listed. Dorman part #14052
asm4mcc Posted March 5, 2010 Author Posted March 5, 2010 ok well i got that bushing for a cj since they changed the crank end size or something but the end of the tranny won't fit inside the bushing so i guess its the wrong one and what is the trick to get that bushing out
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now