Search the Community
Showing results for tags 'bumpers'.
Found 2 results
The time has come for real deal release of the long awaited Krustyballer sliders, bumpers and hitches! Contact Brandon to order your parts. *A $100 DEPOSIT TO PURCHASE MATERIALS IS REQUIRED BEFORE ANY PART WILL BE MADE* Mounting hardware is not included with the sliders or bumpers. You can reuse your stock bolts but they really should be upgraded to grade 8. SLIDERS SWB available in 2"x4" slider (pictured below) and 2"x3" (should have pictures soon) WITH STEP--$335+ shipping WITHOUT STEP--$305+ shipping WITH STEP PLATE--$375+ shipping LWB WITH STEP--$360+ shipping WITHOUT STEP--$330+ shipping WITH STEP PLATE--$400+ shipping XJ SLIDERS ARE AVAILABLE NOW AS WELL!!! WITH STEP--$335+ shipping WITHOUT STEP--$305+ shipping WITH STEP PLATE--$375+ shipping when ordering, make sure you specify what size slider, with or without step and SWB/LWB REAR BUMPERS STANDARD-64" long 2"x4", 2" receiver, 2 d-ring shackle mounts $300+ shipping minus $15 for no 2" receiver minus $15 for no d-ring shackle mounts . Weld on DIY rear bumper brackets. $65 plus shipping. Front bumpers are coming FALL 2019! They will be available in a few different designs as well. You can order them with or without the brush guard or with or without the integrated hitch. Also will have winch bumpers available. HITCHES $225+ shipping (more info in the Hitch thread in the for sale section) I will try to answer any questions on here or through PM if anybody has any. **DISCLAIMER ***If you purchase a fully built hitch, rear bumper or set of sliders, i accept NO responsibility or liability on any of them. once shipped, any failure or problems with performance due to misuse is the buyer's responsibility. Once anything is installed I accept NO responsibility or liability. For liability purposes, hitches and bumpers are not load/weight rated. I cannot say that these can be used to pull or recover. if done so, this falls under misuse of the product and I am no longer liable. Thanks, Brandon S.
Hello Everyone! First and foremost, I am thankful to be accepted into the club! Last week I accomplished a dream of buying a 1988 Comanche (for a whopping 600 bucks). Now behind the journey of getting it back on it's feet! I really only need to swap out a few parts: the bed, passenger fender and the bench seat! The only problem is that I cannot find them!! I was hoping you guys had some experience with this issue and would have some advice! Thanks a lot everyone! The Bandit