jeepthing07

Yahoo Groups

I ordered mine from Sherman parts, the other site sold pans on eBay. I went with Sherman because it was a little cheaper shipping. it goes back a little further than the front seat bracket. and like 2" up the trans tunnel. the trans tunnel was why i tried and failed to make my own pans. i don’t have the best sheet metal working abilities and the curves were a PITA No those are not clear taillights there busted out ones lol. I'm going to drill holes every few inches in the pan above the frame and spot weld the holes to the frame. cherokees don't have the floor support i don't know if I'm going to put one back in or not

my drivers pan was rusted finaly found them here www.surplussupplyco.com/ i havent welded it in yet but i don't think its going to be to hard it fits pretty well. and i think it might be thicker steel than the orginal

Summit Racing has doetsch tech DT3000 on sale for $22 but they don't list them for Comanches anyone have part numbers for the rear shocks with no lift?

I had to weld nuts ontop the bolt heads on a 1997 XJ after i rounded them off

i guess i could allways add a spacer to the coils there cheap enough

tset

I think I'm going to spring over the rear of my comanche and put 4.5 inch coils up front will it sit level with 4.5" coils? and what about the lower control arms will they work for now or do i need to get new ones? and this is a 2wd comanche will my old driveshaft still work? does the tcase have to be droped? I'm going to be running 32's o AR 15x8 black steel rims