Jakeman17

oil change

I went and got my oil changed today and here is what I found out: I need a crankshaft pulley mine is rubbing on case water pump heater control valve flexable rear brake hose also found out I have a Vacuum leak My fuel filter is on wrong Ball joints are good Nothing really broken or hanging The guy said he would buy it off me for 2K.

Replacing thermostat housing

Very nice I like the rear window if selling

I'm hoping we get like 3 feet snow one day

i hope we get that much snow :banana:

lol Thanks Seen pictures of me?? I'm not sure if head is warped

I think I am good wit no air pockets. Yes I have a shroud I have an aux fan not hooked up I'm not sure it looks ok

So here is hat I have done I have tried a high flow housing and a 180 degree fail safe thermostat. I have not been able to get it to seal so I dumped a small amour of stop leak into coolant. Driving around in town I was overheating?? I stop there was coolant in bottle I was sitting in alot of traffic and there was alot of stop and go. Help?

Added a tiny bit of stop leak into coolant

Maybe Check fuel pressure shorted out injected causing all to short(talked about at school lol)

Welcome

There is one under there

Made a Wood box for sand bag for winter comming up

After Driving to school and back today NO LEAKS but no coolant in the reservoir bottle. but i left the cap untightened I make a wood box for sand bags also

I am sure it is in the grooves. The rtv was not all squshed out. Alot of it was added on outside. I have pictures from next attempt last weekend

Just puled it out...... still leaks same spot i know i covered that spot well

Sealed my thermostat housing Hopefully no leaks

My steering is really lose. i gotta look into it soon. but wobble could be caused by so much ball joint control arm bushings

88'' 4.0L 5-speed Manual 2WD I like pictures FYI. The Day I Got It: Sand Bag Box: Exhaust Pipe 31's Image Not Found Image Not Found CB: Image Not Found D30 Before Image Not Found After Image Not Found Image Not Found Soon to come: Tints Sound System Exhaust Tip Roll Bar Light Bar 4WD Conversion(Pending)

Nope i will do so

Here is one of my projects for weekend Image Not Found Image Not Found Image Not Found Image Not Found Image Not Found

Here is what I am doing Image Not Found Image Not Found Image Not Found Image Not Found Image Not Found

Glad its up and running

when I start the jeep sometime there is almost a ticking noise but if I push clutch a little it will stop if I push it all the was it will stop then start again. Sound like it's from clutch fan. Any ideas?