PEEJ Posted October 3, 2014 Share Posted October 3, 2014 Is the full console in an XJ the same as the ones that came in the MJs?If not what needs to be done to make one fit an MJ. Thanks Link to comment Share on other sites More sharing options...
Blood of a Jeep Posted October 3, 2014 Share Posted October 3, 2014 Ive played with this in the past. The biggest difference is the black center tray in a cherokee has the e brake hole. Other wise Ive found them to be identical. Link to comment Share on other sites More sharing options...
HOrnbrod Posted October 3, 2014 Share Posted October 3, 2014 If you use an XJ full console, grab the front air diffuser piece too from the donor XJ when you pull the console. The MJ diffuser w/o a console doesn't work, leaves a gap between the dash and console. You will also have to fab up a plastic plate to block off the rear seat vent tube HVAC outlet. Link to comment Share on other sites More sharing options...
thejim42 Posted October 3, 2014 Share Posted October 3, 2014 I run my radio aux cord and phone charger cord under the center console and out that ebrake slot in mine to keep it all out of the way Link to comment Share on other sites More sharing options...
NHMJXJ Posted October 6, 2014 Share Posted October 6, 2014 I put a '96 XJ full console in my truck ... only thing I did was notch the front to clear the floor heat vent box. Link to comment Share on other sites More sharing options...
HOrnbrod Posted October 6, 2014 Share Posted October 6, 2014 It fits better if you use the full console front air box. Link to comment Share on other sites More sharing options...
NHMJXJ Posted October 6, 2014 Share Posted October 6, 2014 I would think with the correct box, notching wouldn't be necessary either. That didn't cross my mind when I harvested the console. I did think to take the seat belt receivers for the buckets, only to discover later that the male end of a '90 MJ won't fit in the female receiver of a '96 XJ. :doh: Link to comment Share on other sites More sharing options...
PEEJ Posted October 7, 2014 Author Share Posted October 7, 2014 Thanks guys,I've got the doner XJ,so I should be in good shape. Link to comment Share on other sites More sharing options...
Steve Gregory Posted October 7, 2014 Share Posted October 7, 2014 There are some mounting brackets in the XJ that you may need to swap over to your MJ too. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now