tugalo Posted September 18, 2013 Share Posted September 18, 2013 Does anyone know how to separate the firewall connectors from the back side of the fuse block? I know that they are full of the tar that was in the C101 connector and that they have a bolt in between the two halves..... Does anyone have a pin-out of the two connectors? thanks Link to comment Share on other sites More sharing options...
jimoshel Posted September 18, 2013 Share Posted September 18, 2013 There is a bolt in the middle of the block. I don't remember for sure but I think it is 8mm. However it might be a 10mm. Remove the bolt and the back half will come out. There are 4 bolts holding the interior half to the firewall. One at each corner. I don't have the pin outs on the puter but one of the other guys will be on later and help you. Link to comment Share on other sites More sharing options...
Tom Tom Posted September 18, 2013 Share Posted September 18, 2013 Jim you are correct it is 8mm Link to comment Share on other sites More sharing options...
JeepcoMJ Posted September 18, 2013 Share Posted September 18, 2013 or 7 or 6 or 1/4" I've yet to have two of those bolts turn out the same. rust and whatnot. Link to comment Share on other sites More sharing options...
carnuck Posted September 18, 2013 Share Posted September 18, 2013 The '89 was 7mm. I had to borrow the socket from my buddy (engine harness is on my for sale list. No C101 connector and for AW4) Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now