Jump to content

Parting Out 4 Comanches


tommy90

Recommended Posts

  • Replies 84
  • Created
  • Last Reply
Posted

You got any factory sliding rear windows? (gasket mounted) or a gray back panel (the tall one, runs from floor up to the plastic below the rear window), white tailgate or drivers door?

Posted

You got any factory sliding rear windows? (gasket mounted) or a gray back panel (the tall one, runs from floor up to the plastic below the rear window), white tailgate or drivers door?

window yes. Back panel I already sold.others all were gone.got a white tailgate. Has some rust but its fixable.driver door I'd have to check.pretty sure there rotted. But if a Cherokee is the same I have one of those.but power windows.
Posted

 

what about seat belts? Id need either black or gray.

tried lol.took the buckets out of the 90 Eliminator.both seat belt tork bits stripped :(
Posted

I am looking for a grey interior. All the panels, back around the doors and windshield Need a headliner too, I do not need the door panels center console Dash and seats. 201 280-9420

Posted

tried lol.took the buckets out of the 90 Eliminator.both seat belt tork bits stripped :(

One more thing lol, The switch panels that go on the dash next to each side of the column. I have a manual base model comache, but all the panels I have are either from a cherokee, or have auto trans switches. Do you have any that are just blank?

Posted

Do you have any Vacuum Reservoir balls? I need the one that is round with 2 ports. I'm not far from Detroit, so local pick-up is possible. Always looking for other parts as well.

Posted

One more thing lol, The switch panels that go on the dash next to each side of the column. I have a manual base model comache, but all the panels I have are either from a cherokee, or have auto trans switches. Do you have any that are just blank?

 

Nevermind, don't need them anymore sorry

Posted

Do you have any Vacuum Reservoir balls? I need the one that is round with 2 ports. I'm not far from Detroit, so local pick-up is possible. Always looking for other parts as well.

The vacuum balls are common to American cars. The one on my truck now is from a 1980s Chevy Caprice.

Posted

 

The vacuum balls are common to American cars. The one on my truck now is from a 1980s Chevy Caprice.

yea sorry none of them where there anyway.
Posted

looking for the plastic dish that is located in the B pillar that the seat belt mounts into. Need both sides. Got'em? Also shipping to 66106.

 

Thank you

pmed you
Posted

any of them 4wd? i need a driver side axle shaft (inner) for 88 comanche

sorry man I scrapped the 4x4 chief.it was totally stripped no usable parts and crumbling in pieces.

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...