ax 15 clutch line

[asm4mcc]

my clutch line is cut at the slave cyclinder with an inch sticking out how to i go about run a clutch line and what do i use

[Geonovast]

If it's cut far enough down so there's no fitting, then you'll probably be best replacing the slave cylinder. 1" isn't much to work with if you try to add a new fitting.

 

How did it get cut exactly?

[Eagle]

You could try a compression fitting. It might not hold up to the pressure, but I think Pete M used one on a brake line once and got away with it, so it's worth a try.

[asm4mcc]

I'm just goin to the junk yard tomorrow

[Pete M]

You could try a compression fitting. It might not hold up to the pressure, but I think Pete M used one on a brake line once and got away with it, so it's worth a try.

 

 

noooooooo no no no no no no no. They should never EVER be used on brake lines. The pressure is too high.

 

I used a 1/4"to 5/16" adapter compression fitting for connecting my external slave to my original 88 metal line. ti works great for clutch lines since there's far less pressure in there.