90eliminator Posted December 16, 2008 Share Posted December 16, 2008 I have a 90 eliminator.... doing a 4wd swap.... have the original 2wd driveshaft, now need to have it shortened. The driveshaft guy can cut it down but does not have a shop for vehicles, so I need to just give him measurements. My truck is a 90 4.0 AW4 and NP 231.... shortwheel base. I need the measurement from u-joint to u-joint... Can anybody help? Link to comment Share on other sites More sharing options...
Pete M Posted December 17, 2008 Share Posted December 17, 2008 Don't forget to add maybe a half-inch for a 3" lift. Link to comment Share on other sites More sharing options...
90eliminator Posted December 19, 2008 Author Share Posted December 19, 2008 bump...please anyone...I know its cold out, but if someone could do a quick measurement that would be fantastic.... Link to comment Share on other sites More sharing options...
Boilermaker Posted December 19, 2008 Share Posted December 19, 2008 i can measure it on my '92 (also aw4 np 231) this morning. I'll be back from the garage in a couple of hours. Link to comment Share on other sites More sharing options...
Boilermaker Posted December 19, 2008 Share Posted December 19, 2008 44 1/2", 49" including the yoke. Since it was already pulled and laying on the shop floor, I had the guy at the shop measure it. Hope that's what you need. Link to comment Share on other sites More sharing options...
90eliminator Posted December 23, 2008 Author Share Posted December 23, 2008 Many thanks I very much appreciate it....S Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now