90eliminator Posted December 16, 2008 Posted December 16, 2008 I have a 90 eliminator.... doing a 4wd swap.... have the original 2wd driveshaft, now need to have it shortened. The driveshaft guy can cut it down but does not have a shop for vehicles, so I need to just give him measurements. My truck is a 90 4.0 AW4 and NP 231.... shortwheel base. I need the measurement from u-joint to u-joint... Can anybody help?
Pete M Posted December 17, 2008 Posted December 17, 2008 Don't forget to add maybe a half-inch for a 3" lift.
90eliminator Posted December 19, 2008 Author Posted December 19, 2008 bump...please anyone...I know its cold out, but if someone could do a quick measurement that would be fantastic....
Boilermaker Posted December 19, 2008 Posted December 19, 2008 i can measure it on my '92 (also aw4 np 231) this morning. I'll be back from the garage in a couple of hours.
Boilermaker Posted December 19, 2008 Posted December 19, 2008 44 1/2", 49" including the yoke. Since it was already pulled and laying on the shop floor, I had the guy at the shop measure it. Hope that's what you need.
90eliminator Posted December 23, 2008 Author Posted December 23, 2008 Many thanks I very much appreciate it....S
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now