Search the Community
Showing results for tags 'cross-member'.
Hello Everyone!!! I am officially new to the site, but have been browsing for quite some time as this is the best source of information for my new jeep project. I few months back I was lucky enough to pick up an 88 MJ in good shape. it has the 2.5L, so it is kind of a dog but I'm not trying to race anyone or do any rock crawling at the moment. However, I am in the process of installing a 4.5 Rusty's long arm kit, and ran into an issue late into the project last night; I set the lower arms to right specializations (35 3/8" eye to eye only about 3 full rotations of the joint) and mounted them from the cross-member to the axle, but the axle seems too far forward. After calling it a night I have been doing some research; and I know my geometry on the front axle is all jacked up currently, but could my lower arms be too long? I am pretty sure my manual transmission is an AX5 (since it is the 2.5L), but I recall that the trans cross-member is in different locations of about 2" between the AX15 and the Peugeot(87-89???). The only years that Rusty's notes a difference is 87-89 due to the Peugeot mounting a couple inches forward, but does the AX5 and the AX15 mount at the same location? Thanks!