MJXJjeepguy

Yea i know really, lol I have been at some jeep show I seen really nice JK and my guessing I would said personal spending around 20ish-30k dollar just aftermarket parts alone not include the jeep value and with all parts that make for off-road like locker, axle, winch, bumper u name it and never touch the mud, i was umm what the point spending that so much money for a show. But that not my problem, I can't complain about it, it their lifestyle...

AKA - mall crawler

Great information! Now I will see if my still functioning. If not will it be ok to delete? Will it affect MJ with heavy load like atv mostly will use trailer to haul atv.

Starting remove some more plastic panel to take headliner down, will have to take to the upholstery shop have them to put new headliner cover and sun visor also... And if anyone of you guys have spare lamps on the side on panel u want to sell?.... Took headliner off.... Umm... Wonder why some piece missing on foam of headliner from the above?? A MOUSE nest!! Clean it out but no dead or alive mouse to be found yet... Oh my goodness.. That's how much mouse nest is.... Score!! The tailgate off social websote and got it for $150... Other tailgate were missing handle, hinge, and hole rust Can anyone explain what its for? And what it do? I try research but no luck.. I don't know what it called? So the weather had me to stop from working on jeep.. Damn it But yea I do have garage but it full of mess and junky stuff, 4 atv, 2 lawnmower, 4.0 engine parts, transmission and more!... Really need a good spring cleaning so badly.... Hopefully tomorrow will be nicer weather... We will see.. Stay tuned...

I know really?

Ok got ya, u might want pull carpet out soon than wait too long it might not too bad with little surface to tiny hole then u can just bondo kitty hair to cover the small hole but of course clean rust area till u see bare metal then u can start from there, that will be alot easier to do than remove large of metal sheet and put new metal sheet then weld it up, it take alot of time and patient, if u really want to keep the carpet my best advice is put bedliner on floor pan before put carpet back in to protect from begin rust again.

Read the whole page... That definitely make me 110% more motivation!! Beautiful built!!

U got floor pan for MJ? Bec i know XJ and MJ are different, i couldnt find any floor pans for MJ. And yea already check for floor pan before i buy it i have 2nd though about to pass it but couldnt pass it for that kind of deal and always want MJ for few years so this deal was unbeatable ao i grab it, also i have done with floor in 2 different XJ in past one was friend's XJ was one the worse I ever seen had to replace the whole floor it was awful nightmare lol but got it everything work out and now u see i did to my red XJ so now MJ shouldnt be a plm for me to deal with it and the biggest advantages for me is I am a fab welder lol

Got replace radaitor, add electric fan, replace temp sender and Oil presaure sender to work with gauge. Flush out old coolant by remove thermostat and lower radiator hose, then put 50/50 antifreeze in and let it run for about 30 mins while coolant burp to make sure no air inside cooling system after 30 mins of running then took a drive for 10 mins without overheat checked oil to be sure no water in oil no white smoke out of exhaust everything seem good with engine. Then took front end off my 98 XJ donor and put on MJ right now it not bolt in it just sit rest.... I like it! Goodbye to the bench seat. Now the worse parts...... I have to be extra EXTRA carefully removing all the plastic panel or I will have hard time find other panel for MJ but everything got out good with no damage.

I checked in.

Reg. 96 XJ and 91 MJ, parts jeep 98 XJ 96 XJ and 99 WJ

Just thought wanna show u guys the floor pan I did in my 96 XJ, current still own it. This is my baby XJ...

I just notice now by u saying i got bench with headrests lol but planning to put WJ black seat in after i get floor pan fix it pretty rust out....

Went to junkyard today and score radiator and electric fan out of 98 and good flushed out, it was really dirty also got 6 gauge dash cluster out of 96 with only 101k miles also went stop by advance auto store pick up temp sender and oil pressure sender to work with 6 gauge dash cluster. Stay tuned for more tomorrow....

Got myself comanche couple week ago in Columbus Ohio and drive back home in WV about 6 hours round trip. Got overheated issue and still work on whenever weather is permits.. I found what's missed is electric fan Also found radiator leak so PO didnt know? Let find out soon...