1989 comanche mj

I have always wanted that grille headlight setup, do you have to use the header panel from the donor truck? I haven't taken one apart in a while, I am guessing the second light mount is only on that specific panel? Were they 85 86 only? Are they standard headlights or a little smaller than the normal trucks?

Thanks for the replies. I just looked them up and noticed it says 84 to 01? If anybody can confirm that I have a 98 xj hit in the front that I could cut the pans from. I replaced floor pans in a 99 xj once, and used cut donors from a 93. They were different, however I replaced front and rear sections and don't recall if just the backs were different.

I have been searching all over, and getting conflicting info. Some people say xj pans work fine, some say no. 92 MJ 5 speed 4x4 4 liter short bed. I want a factory look, and have a plama cutter and mig. I don't want to just slap down sheet metal, want it to look factory. Its rotted from the start of the tunnel curve to the rocker, frame unibody rail looks fine but the floor above it is rotted away. Please tell me what brand, where to get them, or something.

I have an 89 Comanche 4 liter 5 speed peugeot 2 wheel drive. I just picked up a 99 Cherokee 5 speed 4 wheel drive 4 liter. Can I just use the cherokee transmission, transfer case and transfer case crossmember along with the front axle and driveshaft? Also, which clutch should I use, or are they the same?