AeroNautical Posted January 6, 2021 Share Posted January 6, 2021 Some before and after shots of my recent floor repairs. What do you guys think? Link to comment Share on other sites More sharing options...
Jesse J Posted January 6, 2021 Share Posted January 6, 2021 they look good! where did the crossmembers go? Link to comment Share on other sites More sharing options...
AeroNautical Posted January 6, 2021 Author Share Posted January 6, 2021 4 minutes ago, Jesse J said: they look good! where did the crossmembers go? I did alot of research online about keeping vs eliminating, and found they weren’t really needed. The driver side was completely gone, and the passenger side was too far pitted to salvage. I just cut where the studs were and welded those sections back in. Link to comment Share on other sites More sharing options...
Jesse J Posted January 6, 2021 Share Posted January 6, 2021 1 minute ago, PFCLeist said: I did alot of research online about keeping vs eliminating, and found they weren’t really needed. The driver side was completely gone, and the passenger side was too far pitted to salvage. I just cut where the studs were and welded those sections back in. ok cool they look really good. was that rattle can bedliner? Link to comment Share on other sites More sharing options...
AeroNautical Posted January 7, 2021 Author Share Posted January 7, 2021 On 1/6/2021 at 12:06 PM, Jesse J said: ok cool they look really good. was that rattle can bedliner? The base was por 15, then a floor pan primer, and two coats of a spray on bedliner. for the underside by the exhaust I used a ceramic high temp coating. And thanks Link to comment Share on other sites More sharing options...
ghetdjc320 Posted January 7, 2021 Share Posted January 7, 2021 Your floor mats will fit better without the braces lol Link to comment Share on other sites More sharing options...
AeroNautical Posted January 8, 2021 Author Share Posted January 8, 2021 18 hours ago, ghetdjc320 said: Your floor mats will fit better without the braces lol Your right, haha. I think I’ll leave them bare, though. I put rubber drain plugs on each side I’ve been using alot, and until i find this leak, ill leave em out Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now