RochesterMJ Posted November 18, 2013 Share Posted November 18, 2013 I've got manual windows and when I roll the drivers window down the "weatherstrip Glass Inner Seal" (#2 in the pic) tends to fold over and I have to push down on the glass while cranking to get the window all the way down. I've tried the dry silicone spray (temporarily helps), tried trimming them back (didn't help, looked like crud), and replaced them with seals from the JY that looked like they had more flocking (the fuzzy part) (no change). Its been like this for a while but I can't remember if its always been like this, I've had the trim panels off a couple times, did I mess something up when I reinstalled them? Is there a way to adjust the seal away from the glass or tilt it so its not pressing against the glass as hard? Link to comment Share on other sites More sharing options...
jeepsouth Posted November 18, 2013 Share Posted November 18, 2013 I too have this problem ,and would be very interested to know how to correct it. Link to comment Share on other sites More sharing options...
gogmorgo Posted November 18, 2013 Share Posted November 18, 2013 When I put my door panels back on once, they were weird at the top so I pulled them back off and noticed that I forgot to clip them back into the thing at the bottom of the window. Could that be your problem? Link to comment Share on other sites More sharing options...
RochesterMJ Posted November 18, 2013 Author Share Posted November 18, 2013 I'll have to double check. Link to comment Share on other sites More sharing options...
jeepsouth Posted November 19, 2013 Share Posted November 19, 2013 Just found my build sheet behind the drivers side door panel! It's in pristine condition too. Link to comment Share on other sites More sharing options...
RochesterMJ Posted November 19, 2013 Author Share Posted November 19, 2013 Checked the seals and they're installed correctly. Figure its either worn out or when I had it off I might have bent the metal carrier and its now pushing the seal into the glass too much. Will have to experiment next time I pull the door panel off - don't care enough to mess with it in the cold Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now