Jump to content

Recommended Posts

Posted

Will a 5 speed and t case out of a 1995 yj i4 bolt up to my 88 2.5 mj looking to so a 4x4 swap and trying to figure tcase out and the extra gear would be nice any feed back would be great thanks

Cody

Posted

So the bell housing will bolt up to the back of the block?

And i don't think that would make to much of an issue slightly different drive shaft angles?

Posted

5th gear won't be much use to you. The 2.5 tends to dog pretty bad in 5th with 3.55 axles. I did the same thing with an MPFI 2.5, and didn't even bother with 5th unless I was doing more than 70 on level ground.

 

You can still use the trans obviously, for the 4wd conversion, but if you rely on 5th a lot, your mileage is probably going to go down. Just something to keep in mind.

Posted

Hmm thats good to know the front axle i am looking to get has 3.55s i was gonna jack the back up to check before i buy it and could tail shafts be swaped to make the 4 speed work?

And thats shocking never knew that with 5th gear I'm still pretty new to the mj world lol

Posted

Not sure, I started car pooling just before I did the gears so it doesnt see much time on the road anymore.

 

I would guess 18-20mpg but fuel mileage tends to average a little lower here due to terrain and our ethanol blend gas.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...