Blue88Comanche Posted October 16, 2012 Share Posted October 16, 2012 I found this connector unplugged, i assume its not needed for my factory setup (4.0, Manual). but does anyone know what this connector should connect too? the wires go into the same shield as the ones from the TB. Link to comment Share on other sites More sharing options...
ComancheKid45 Posted October 16, 2012 Share Posted October 16, 2012 The Automatic transmissions use a different TPS setup that involves 2 plugs. That is the other 1. Link to comment Share on other sites More sharing options...
Blue88Comanche Posted October 16, 2012 Author Share Posted October 16, 2012 I had been thinking about swapping to the aw4, I know I need to swap a wiring harness but I am not sure what it is called to look it up and locate on the donor. do all the wiring harness have this other connector? or I'd it possible that somewhere along the line my harness was replaced with one for an automatic? thanks Link to comment Share on other sites More sharing options...
Akula69 Posted October 17, 2012 Share Posted October 17, 2012 The engine bay harness in Jeeps that have the AW4 have two connectors for it (on the passenger side of the engine bay back by the fire wall and transmission dipstick). I have seen one 4 cylinder MJ that did not have these plugs on the engine bay harness, but by far the majority I have seen have them, even if not used. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now