AZRick Posted October 8, 2012 Share Posted October 8, 2012 When I turn the key on I can hear the pump prime but then it shuts off and I hear the relay click in the engine bay. The fuel filter has been removed but there ain't nuthin coming out. I would expect the pump to keep running and splooge gas everywhere with the filter removed? What gives? 1990 Comanche, 4.0 Link to comment Share on other sites More sharing options...
Comanche County Posted October 8, 2012 Share Posted October 8, 2012 Try swapping in another relay. Could be a relay but they don't burn out very often. Follow all the wires going back to the pump and look for a short or worn wire. But, could just be time for a new fuel pump. Link to comment Share on other sites More sharing options...
Dadinator Posted October 8, 2012 Share Posted October 8, 2012 Yep. I'm guessing the fuel pump went south for the winter. Link to comment Share on other sites More sharing options...
AZRick Posted October 9, 2012 Author Share Posted October 9, 2012 Jumper power to the ballast resistor, the pump runs and fuel flows into catch container. Questions; 1. When turning key to ON, how long is relay energized if no start is attempted? 2. Is relay re-energized when cranking engine? 3. Does ECU energize relay to supply power to ballast resistor when engine is running? I'm thinking; 1. 2 seconds, just to top up fuel pressure. 2. Yes. 3. Yes again. If my assumptions are correct, 1. is good but pump does not run long enough to pressurize system (we have been sitting for a very long time), have to check on 2., can't check on 3. cause it won't run ... yet. First step, re-install fuel filter and jumper power to ballast, pressurize the system. Link to comment Share on other sites More sharing options...
cruiser54 Posted October 9, 2012 Share Posted October 9, 2012 The hose between the pump and the flange on the tank unit can very well be bad. Link to comment Share on other sites More sharing options...
AZRick Posted October 21, 2012 Author Share Posted October 21, 2012 The hose between the pump and the flange on the tank unit can very well be bad. Exactly, the outer layer of the hose had rotted away, the clamp was loose and it disconnect it's self... New pump and all better, it runs, time to get on with getting all the little nit noids put back where they belong. :banana: Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now