yaaaaa....now my flares

[STERLING STINGER]

i have no idea how to put my rear flares on....there is bent sheet metal now where the original body was so there is no holes. can't i just drill holes in it and zip tie them on? or does anyone else have any ideas?

 

thanks again for the millionth time

paul

[freakjeep93]

drill holes and use normal bolts and nuts i think. ive never done it myself... yet

[maddzz1]

I believe the size most people use are 1/4" x 20 bolts with fender washers

 

Do you still have the metal plates with the studs or did they all brake during removal?

[STERLING STINGER]

no metal platss at all

[maddzz1]

Then you just have to drill the holes and use the bolts/washers listed above.

[CWLONGSHOT]

I believe the size most people use are 1/4" x 20 bolts with fender washers

 

Do you still have the metal plates with the studs or did they all brake during removal?

 

CK my build thread.. this is what I did! I also have some ideas for fender stiffeners...

 

CW

[wannabeMJ]

I believe the size most people use are 1/4" x 20 bolts with fender washer

Do you still have the metal plates with the studs or did they all brake during removal?

 

what's a fender washer

[mfpdm]

what's a fender washer

 

Midget with a sponge. :D

 

 

:cheers:

[wannabeMJ]

what's a fender washer

 

Midget with a sponge. :D

 

 

:cheers:

 

can't seem to find that at the store :dunno:

[maddzz1]

I believe the size most people use are 1/4" x 20 bolts with fender washer

Do you still have the metal plates with the studs or did they all brake during removal?

 

what's a fender washer

 

Basically a big washer. Check this thread (CWs build) http://comancheclub.com/forums/viewtopic.php?t=1230

The ninth post down (the one after the rock sliders) and there is a pic of CW holding up the sheet metal stiffener he made and you can see one in the pic

[STERLING STINGER]

i got them