egghead Posted October 9, 2006 Posted October 9, 2006 OK so i'm on the verge of getting everything ready for four wheel drive. I have an 87 MJ 4.0L Automatic. I'm going to be putting in an AW4 Tranny and NP231 T-case. I need to know how long my drive shaft needs to be. I'm planning on cutting the 2wd one down and using it. Anyone know what the length would have to be? Thanks Egg
87manche Posted October 9, 2006 Posted October 9, 2006 you longbed or short Aaron? I've got a shortbed driveshaft in the garage that belongs to Jeff, I could measure that, or I can measure my LWB d-shaft, but it's an AX-15. Not sure if the trans length is significantly different.
Pete M Posted October 10, 2006 Posted October 10, 2006 An AW-4 itself is longer than an AX-15 so the d-shafts will be off by like an inch or so (with the AX-15 having the longer d-shaft). If he's adding a lift, he might be able to use that extra inch.
Zirzow Posted October 13, 2006 Posted October 13, 2006 When i did the 4wd swap on my truck i used the AW4 and an np242. I cut down my drive shaft. My measurment was 48 3/4 inches. Hope that helps.
Oizarod115 Posted October 13, 2006 Posted October 13, 2006 one thing is that the rear shaft isnt going to be a slipshaft and the front needs a slipshaft
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now