Search the Community

Starting up my thread for my Comanche build. As it sits today, its a 1992, 4.0L, 5Sp, 2wd, SWB, Dana 35 that runs and drives fine with a few small issues. Overall, looking to make it go anywhere and be able to daily drive if needed. Currently, its being used off and on for quick rides/errands. History: Bought it from @kryptronic last fall Installed 2 new tires, changed oiled and trans fluid to get ready for inspection Passed PA inspection with the addition of license plate lights (the only one i didnt check) Picked up a 99 Donor with a blown engine for the start of the 97+ swap (4wd, 5sp, dana 30 and dana 35) Fixed a power steering leak Bought a (supposedly) XJ Dana 44 rear axle with what the seller thinks were 4.56 gears and no mounts for $100 Sold to a jeep aficionado here just south of Pittsburgh. Current Issues: Damp Floorboard (need to investigate more) Some weather stripping is rough Multiple Dents/Dings (especially in the bed) Windows are rough to roll down Plans: 97+ Conversion (interior and exterior) Onboard Air Air lockers possible axle shaft upgrades Determine gearing (will depend on lift/axles) SOA Rear Front lift (3 Link, 4 Link?) Steering Upgrades Bumpers, rock sliders, bed rack, bed sliders? Lighting upgrade (LED or halogen, adding fogs) Tires/Wheels Paint/body panel fix Frame stiffeners? Engine Rebuild/Stroker/LS Swap TBD Pic Dump (a few from the day i brought it home and of the parts jeep):

Alright guys, I'm going from a 2WD Peugeot (internal slave) to a 4WD AX-15 (external slave) in my recently acquired '88 SporTruck. I've disconnected the lines at the slave end and clamped the hose for the time being. My question is, since I'm going to an external slave, can I just mate the hydraulic line from the Peugeot master to an AX slave? The master cylinder looks to be fairly new (PO said it was, anyway). Just trying to save money if I can because the whole hydraulic system, prefilled, is $100+ on RockAuto. Just the slave is ~$35.