where can i buy

[maddzz1]

bushings for my D30. I am putting in some RE uppr control arms and want to replace the bushings on the axle. Rockauto has upper control arm bushings but i figure those are for the control arm itself and not the axle end.

[mjeff87]

NAPA....about $10 each

 

Jeff

[mfpdm]

bushings for my D30. I am putting in some RE uppr control arms and want to replace the bushings on the axle. Rockauto has upper control arm bushings but i figure those are for the control arm itself and not the axle end.

 

UCA bushings are the same as the axle bushings.

 

:cheers:

[JeepcoMJ]

replace them WHILE the axle is OUT of the jeep.

 

if you weren't taking it completely out...you may as well (if you're doing a complete lift right now)

 

then you can use a large hammer to knock the old ones out and put the new ones in. in the vehicle, there's no swinging room and you will need something like a ball joint press to put them in the axle.

 

also, pay attention to how the old ones were installed...it does matter.

[maddzz1]

Jeepco, I was just going to swap in some uppers for now and do the full lift later on. Should I wait to do the bushings when I do the full lift? and just put the uppers in for now?