velco Posted September 27, 2021 Share Posted September 27, 2021 I am replacing a 10/5 rear mount original with a crown replacement and noticed that the original has a center pin that appears to be welded or pressed in. The crown has the holes but no pin. Is that pin important and how to remove it if I need to transfer it to the new part. New part installed fits and works like a charm. Old mounts rubber was very spongy causing a bit of drive train flutter. Link to comment Share on other sites More sharing options...
pizzaman09 Posted September 30, 2021 Share Posted September 30, 2021 It's been too long since I did mine to remember the details so I can't answer your pin question. But I absolutely agree with the reduction of drive train flutter. It was a masive improvement in reduced vibration while moving off in first gear or just getting on and off throttle. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now