Jeepingisfun Posted April 22, 2020 Share Posted April 22, 2020 hi guys its been awhile since i have made a post, last time i was talking about myy fuel not pumping, i took apart my fuel pump and sender and tested both on a car battery and it started pumping, i replace my old fuel relay with a new one, but it is still not flowing gas is it possible my ground wire behind the tail light is bad i looked at it and the connector was covered in dirt and other stuff and i can't remove the screw cause of how old it is anyreommendations on what to do? Link to comment Share on other sites More sharing options...
JMO413 Posted April 22, 2020 Share Posted April 22, 2020 I would do this. http://cruiser54.com/?p=249 Link to comment Share on other sites More sharing options...
Jeepingisfun Posted April 22, 2020 Author Share Posted April 22, 2020 so would i use the same ground wire or would i need to use a new ground wire for this to work? Link to comment Share on other sites More sharing options...
JMO413 Posted April 22, 2020 Share Posted April 22, 2020 You technically add an extra ground. You run a new ground wire closer to the pump any tie it into the factory wiring. Link to comment Share on other sites More sharing options...
Jeepingisfun Posted April 22, 2020 Author Share Posted April 22, 2020 ok i will try this and let you guys know if it works thank you Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now