mark corbitt Posted December 18, 2019 Share Posted December 18, 2019 So i replaced my wiper motor assembly and when i went to plug one of the washer hoses back in the little plastic fitting broke. I have a spare cowl with one good nozzle, so before i break it i just wanted to ask is there a certain way to remove the nozzle from the cowl? Link to comment Share on other sites More sharing options...
eaglescout526 Posted December 18, 2019 Share Posted December 18, 2019 Mark. It looks like it’s being held in by a pin. If you can pull the pin out it should slide out of where it’s being held in at and do a swap. Seems like I’m gonna need to snag a few nozzles. Link to comment Share on other sites More sharing options...
mark corbitt Posted December 19, 2019 Author Share Posted December 19, 2019 Thank you, without my reading glasses i never would have found the "pin" and would surely have broken the replacement nozzle getting it out of the cowl. Hats off to you!!! Link to comment Share on other sites More sharing options...
eaglescout526 Posted December 19, 2019 Share Posted December 19, 2019 No problem. I have yet to replace any nozzles but was trying to remove them before painting the cowl but didn't have the patience to sit and do it without a back up nozzle. Glad you got it off though! Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now